iWALK DLB6000M PowerGrip Mag Wireless PowerBank User Guide
- June 13, 2024
- iWALK
Table of Contents
iWALK DLB6000M PowerGrip Mag Wireless PowerBank User Guide
- This wireless charger is not compatible with non-MagSafe phone cases, such as Otterbox Defender cases.
- Do not use an adapter with an output of 5V/1A (5W) or less.
- Wireless chargers make charging more convenient than wired chargers, but confined by current wireless technology, their charging speed is slower than that of wired chargers.
- High temperatures will reduce charging speed and restrict power, which is something that happens to all wireless chargers. It is recommended that you charge your device in environments with temperatures below 25°C / 77°F.
- Both the protective phone case and the position of your device on the wireless charger will affect the charging speed. The farther it is placed from the center of the wireless charger, the slower the charging speed will be.
Product Introduction
- Open the power button first
IMPORTANT SAFETY INSTRUCTIONS
Please make sure to notice the following reminder:
- Please store this product in a cool and dry place. Do not place this product in a car, kitchen, or other high-temperature or humid environments. It must not be exposed to water or heat, and should not be placed near an open flame to prevent any potential hazards.
- Please charge the product by using the matched charging device. Don’t use the power supply, charger, charging line to charge the product in case cause damage to the product or lead to fire hazard to cause personnel damage and other adverse consequence.
- The working temperature shall fall between 0°C and 40°C (32°F-104°F).
- Please don’t dismantle the product. If the product needs to service or maintenance, please contact the after-sale maintenance personnel of the manufacturer to assist to process, so as to avoid causing the damage to the product or other dangerous.
- If not used for a long period of time, the product shall be charged and discharged once every three months.
- When charging, the product may be hot, which is normal and there is no need to worry.
- Under normal use, battery performance may gradually degrade in a few years.
- Improper use, falling or excessive force may damage the product.
- When disposing of old and useless batteries, please separate the batteries of different electrochemical systems.
Connecting
-
Snap and magsafe charging
-
USB-C wired charging
-
Recharging the PowerGrip
Recommend to connect USB wall adapter with PD, Quick Charge 2.0/3.0 output to optimeze the charging efficiency.
Press the power button to use the Pass-through Charging
Specifications
-
Product Name: PowerGrip Mag
Model No.: DBL6000M -
Capacity: 6000mAh(3.7V/22.2Wh)
-
USB-CIn/Out: 5V-3A,9V-2A, 12V-1.5A
-
Wireless Charging: 5W/7.5W/10W/15W
-
Size: 106x67x20mm
-
Weight: 144g
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
device a distance of 0 cm surrounding the device and 0 cm above the top
surface of the device must be respected.
IC Statement
This device complies with RSS-216 of Industry Canada. Operation is subject to
the condition that this device does not cause harmful interference.
RSS-Gen Issue 5 March 2019
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RF Exposure statement:
The equipment complies with IC Radiation exposure limit set forth for
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
This device complies with Industry Canada license-ICES-003. Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
This digital apparatus complies with CAN ICES-003(B)/NMB-003(B).
Warranty card
Thank you for purchasing the iWALK product.
Our product’s warranty period is 12 months starting from the date of purchase.
Within the warranty period, free service will be provided to the consumer, if
the product has any quality problems (requiring warranty card with
distributor’s official stamp and valid S/N).
Paid service:customer will incur a repair charge as follows:
- No valid warranty card or warranty card incompatible.
- No S/N or S/N incompatible with warranty card
- Malfunction caused by artificial damages (like external impact or submerging product into water,ect.)
- Misuse of the product.User has not followed the instructions in the manual.
- Product disassembled or repaired by individual or unauthorized service center.
- Damages caused by storing the product in a hot or humid environment.
- Defects or malfunctions due to force majeure.
UK Authorized Representative T
HEMISAR Support Itd.
85 Great Portland St, London, United Kingdom,
W1W 7LT Christopher Jones
Tel: +44-(0)20-37332302 legal@themisar.com
EU Authorized Representative
Real Solutions Haarlem B.V
A.Hormanweg 75-2031BH Haarlem,
Netherlands
Tel: +31-(0)88-9277277 Contact: Mike de Zwart,MSc
US 1-888-961-5888 | 24/7 service
UK 44-20-3885-0855 | 24/7 service
CN 400-8855-698 | Mon-Fri 09:00-17:00
Head Office 86-592-5030-771/780 | Mon-Fri 09:00-17:00
@iWALK.Fans @iWALKKOREA @iWALKJAPAN
U20 GLOBAL CO.,LTD.
Head Office/Manufacturer: U20 Building, Huanzhu Road 385,Jimei,
Xiamen,Fujian,China
U.S. Office: 206 Terminal Drive Plainview, NY 11803
Dubai Logistic Center: 201, Atrium centre, Bank Street, Bur Dubai, UAE.
Korea Office: 4.19-ro 13-gil, Ganbuk-gu, Seoul, Korea
EU Logistic Center: A. Hofmanweg 75-2031BH Haarlem, Netherland
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>