iWALK V10A Cell Phone and Watch Power Bank User Manual

June 12, 2024
iWALK

iWALK V10A Cell Phone and Watch Power Bank

iWALK V10A Cell Phone and Watch Power Bank

Thank you for purchasing and using this product!

Please read this operation instruction carefully before using this product

Attention

  1. Do not squeeze or collide vigorously.
  2. Please do not disassemble or put into the fire or water in the powered state to avoid short circuit and leakage.
  3. Please do not use in severe high temperature, high humidity or corrosive environment to avoid damage to the circuit and leakage.
  4. Please do not place magnetic cards with magnetic stripes or chips (ID cards, bank cards, etc.) on the wireless charging board to avoid magnetic card failure.
  5. Please do not place metal ( coins and other metal objects) on the wireless charging pad while charging, to avoid heat damage.

Specifications

Battery Capacity 5000mAh
Lightning Input 5V 2.0A/ 9V 2A
Type C Input & Output 5V 2.5A/ 9V 2A/ 12V 1.67A
Built-in Cable Output 5V 2.5A/ 9V 2A/ 12V 1.67A

Apple Watch
Output Power| 3W

for Fast charging mode, 18W or above power adapter is required as its power source

Product Detail Part

Product Detail Part
Product Detail Part

Product Description

Product Description

  1. 5000mAh lithium battery.
  2. It can charge cell phone and Apple Watch at the same time.
  3. When using wired charging alone, the output is 20W fast charging and supports PD/QC3.0 fast charging protocol.

FCC Statement

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation

Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

SymbolMADE IN CHINA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals