Danfoss 088U1081 Icon™ Display 24V Room Thermostat F86 OW Installation Guide
- June 4, 2024
- Danfoss
Table of Contents
Danfoss 088U1081 Icon™ Display 24V Room Thermostat F86 OW
Installation
Proceed according to Fig. 1 to 9 (disassembly procedure, see Fig. 10
to 12).
Note, Fig. 3: Thermostats can be connected in a bus configuration or to
the star. For more information, see the Master Controller Installation Guide.
Note , Fig. 13: The optional floor sensor must always be routed to the
installation tube, the so-called goose neck!
Installation menu
- Open the Settings menu by pressing and holding the button him. By pressing and holding the button again in the Settings menu you go to the Installer menu (Installation menu).
- Offers
- Limitation of the desired temperature range in the room.
- Information / version number, can be used to identify the product.
- Performs a connection test with the main controller. Returns a result of the form percentage values 0-100% (80% or higher is very strong connection).
- Floor sensor mode:
- Comfort mode. A room and floor sensor is used.
- Floor sensor mode. The end user sets the desired floor temperature.
- Dual mode. The thermostat controls the radiators and floor circuits heating. Floor heating circuits provide min. floor temperature, and the radiator is used for peak loads.
- Min. and max. floor temperature used in modes and .
- Reference room. Turn this option ON if you want it to this thermostat acted as a reference for switching between cooling and heating.
- Turn on/off (ON/OFF) cooling. It is used to disable the option cooling, for example in bathrooms.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>