niko PM353-852411 Motion Detector Installation Guide
- June 13, 2024
- niko
Table of Contents
Manual
Motion detector
353-852411
Motion detector M48HC, DALI-2, master, high ceiling, 18-53 m, 360°, for surface mounting
Wiring DALI power – OFF
- 353-852411 master
- 353-x52011 secondary
- DALI zone 1
- DALI zone 2
- DALI zone 3
- DALI zone 4
This product must be secured with a miniature circuit breaker (MCB) of max. 16 A in the electrical cabinet. The MCB rating is limited by national installation rules.
Dimensions
Installation DALI power – OFF
[1]
[2]
[3]
[4]
[a] [b]
[5]
[a] [b]
* optional
If a grommet needs to be replaced, please make sure the new grommet is halogen-free.
Dismantling 230 V – OFF
[a] [b]
App settings DALI power – ON
| | |
---|---|---|---
Factory settings| Switch ON/OFF| 500 lux|
15 min
detector tool
LED behaviour DALI power – ON
Green LED continuous on
| | Connection OK|
---|---|---|---
Green LED breathing| |
Connection OK, overrule ON
|
Green LED flashing| | Warming up| Wait
Red LED continuous on| | Error|
More info –>
detector tool
Red LED breathing| | Warning
Blue LED flashing| |
Walk test active
Specifications
Article number|
353-852411
---|---
Configuration|
DALI-2 master
Input voltage|
230 Vac ± 10 %, 50 Hz
Maximum power consumption|
0.6 W
Maximum power consumption wireless link active|
0.65 W
Short circuit behaviour shutdown trigger|
voltage below 12 V, exceeding 1.3 s
Short circuit behaviour restart period|
every 14 s until success
Detector output|
DALI Broadcast/DALI Addressable
Maximum voltage on the DALI bus|
15 Vdc
Maximum guaranteed current on the DALI bus|
200 mA
Maximum supply current|
250 mA
Maximum startup time DALI|
< 1200 ms
Maximum PIR detection startup time|
70 s
Maximum number of dimmable zones|
4
Maximum number of control gear on the DALI bus|
64
Circuit breaker|
maximum MCB rating 16 A*
Relay contact|
NO (max. µ10 A), potential-free
Maximum load incandescent and halogen lamps (cosφ = 1)|
2300 W
Maximum load fluorescent lamps (cosφ ≥ 0.5)|
1200 VA
Maximum load economy lamps (CFLi)|
350 W
Maximum load LED lamps 230 V|
350 W
Maximum load LED driver|
500 VA
Maximum load electronic transformer|
500 VA
Maximum switching current|
165 A/20 ms – 800 A/200 µs
Maximum capacitive load|
140 µF
Light intensity range|
20 – 2000 lux, ∞
Number of channels|
1 channel
Switch-off delay|
pulse, 20 s – 120 min, ∞
Detection angle|
360°
Detection range (PIR)|
Ø 53 m from a height of 12 m
Ambient temperature|
-25 – +40 °C
Mounting method|
surface-mounting
Mounting height|
4 – 12 m
Colour|
white (RAL 9010)
Dimensions (HxWxD)|
100 x 100 x 70.7 mm
Dimensions visible (HxWxD)|
100 x 100 x 70.7 mm
Wire capacity|
1.5/2.5 mm²
Maximum range Bluetooth® (free field, depending on the device)|
50 m
Maximum radio frequency power|
-2 dBm
Operating frequency|
2.4 Ghz
Protection degree|
IP54
Impact resistance|
IK04
Modification of settings|
app (iOS/Android) and 2-way Bluetooth® communication
Halogen-free|
yes
Marking|
CE
- The MCB rating is limited by national installation rules
Detection area
H
| A
Walking
| B
Across
| C
Towards
---|---|---|---
4.0 m| ø 18 m| ø 18 m|
ø 11 m
8.0 m
| ø 35 m| ø 33 m| ø 23 m
12.0 m| ø 53 m| *|
ø 13 m
- not specified
Measured according to EN/IEC63180
Troubleshooting
| Problem | Possible cause | Proposed solution |
|---|---|---|
| Load does not turn on | The wiring is not correct | Check the wiring |
scheme
The ambient light is too strong| Check the response value luminosity and raise
the value if necessary
Load does not turn off| The switch-off delay is too long| Check the
switch-off delay and shorten the delay if necessary
The detector receives false triggers| Check for any objects that may cause
false triggering and remove them from the detection range or lower the
sensitivity
App cannot connect to the detector| Bluetooth® has been disabled on your
mobile device| Enable Bluetooth® on your mobile device
Support & contact
nv Niko sa
Industriepark West 40
9100 Sint-Niklaas, Belgium
EN
| +32 3 778 90 80| support@niko.eu
---|---|---
NL
| België: +32 3 778 90 80
Nederland: +31 880 15 96 10| support.be@niko.eu
support.nl@niko.eu
FR
| Belgique: +32 3 778 90 80
France: +33 820 20 66 25
Suisse: +41 44 878 22 22| support.be@niko.eu
support.fr@niko.eu
support.ch@niko.eu
DE
| Deutschland: +49 7623 96697-0
Schweiz: +41 44 878 22 22
Österreich: +43 1 7965514
Belgien: +32 3 778 90 80| support.de@niko.eu
support.ch@niko.eu
support.at@niko.eu
support.be@niko.eu
DK
| +45 74 42 47 26| support.dk@niko.eu
SE
| +46 8 410 200 15| support.se@niko.eu
NO
| +47 66 77 57 50| support.no@niko.eu
IT
| +41 44 878 22 22| support.ch@niko.eu
PL
| +48 509 378 373| support.pl@niko.eu
SK
| +421 2 63 825 155| support.sk@niko.eu
Niko prepares its manuals with the greatest care and strives to make them as complete, correct and up to date as possible. Nevertheless, some deficiencies may subsist. Niko cannot be held responsible for this, other than within the legal limits. Please inform us of any deficiencies in the manuals by contacting Niko customer services at support@niko.eu.
PM353-852411R22282
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>