flow u-sonic 3 Rechargeable Mini Ultrasonic Cleaner Instructions
- June 13, 2024
- FLOW
Table of Contents
**flow u-sonic 3 Rechargeable Mini Ultrasonic Cleaner Instructions
**
Perfect cleaning and care with ultrasound
Especially for small products, germ-free, deep cleaning is important for daily use, personal hygiene and value retention. Powerful ultrasound at 42 kHz ensures hygienic cleanliness even with clear water.
Initial operation
- Plug the USB cable into a USB power supply (5V/2A) and the USB-C plug into the socket on the rear of your u-sonic 3.
- Then plug the power supply unit into a mains socket.
The u-sonic 3 is charged in approx. 3 hours and is ready for operation for approx. 7 short cleanings or 3 intensive cleanings.
LED 1 flashes green.
LED 1 lights up green
Operation
- Fill the stainless steel tub of the u-sonic 3 with water up to the mark. You can also use the lid for this purpose.
- Place the parts to be cleaned in the cleaning basket or directly into the water and close the lid.
- Touch the sensor button 1x briefly and the ultrasonic cleaning starts in the short program 4 minutes.
- Touch the sensor button 2x briefly and the ultrasonic cleaning starts in the intensive program 8 minutes.
- After ultrasonic cleaning is completed, the unit automatically switches off in stand-by mode.
- Open the lid and remove the cleaned parts
- After each cleaning, empty the water into a drain basin
LED 2 display flashes
LED 3 indicator flashes
all LEDs switch off
Maintenance and care
- Switch off the unit and disconnect the power plug before each cleaning and maintenance.
- After ultrasonic cleaning, rinse the cleaned parts with running water. Tubes and holes must be blown through well and dried.
- Simple cleaning is done with clear water. For intensive cleaning, a cleaning concentrate is recommended as an additive or a splash of mild detergent.
- If you touch the sensor button for longer than 3 seconds during ultrasonic cleaning, you can manually switch the unit to stand-by.
- To clean your u-sonic 3, we recommend wiping it with cleaning damp cloths.
Application examples
Earplugs, swimming and sleeping protection, mini tubes, ear olives and domes, coins, medals, badges, razor shaver heads, drawing pens, dental prostheses, braces, cosmetic utensils, infant teats, nipples, ear jewelry, necklaces, rings and other jewelry items that are ultrasonically cleanable; ask your jeweler!
! Warnings
Never place electronic devices in the liquid! Only ultrasonic cleanable parts
may be cleaned in the u-sonic 3! The u-sonic 3 must not be operated near
washbasins or similar – risk of electric shock! Never operate the u-sonic 3
without water in the stainless-steel tank! In case of malfunctions, please
disconnect the power plug and take the unit to the dealer. Do not disassemble
the unit. Avoid mechanical stress due to impact and falling! The u-sonic 3
must not be operated near fire or easily combustible objects! Batteries do not
belong in the hands of children. Do not heat the battery above 60 °C (140°F)
and do not throw it into fire: risk of explosion and fire! Do not short-
circuit the battery! Never discharge the battery completely, this will shorten
its lifetime. If the battery is to be stored for a longer period of time, a
residual capacity of approx. 30% is recommended. This device is not intended
for use by persons with reduced physical, sensory or mental capabilities, or
lack of experience and/or knowledge, unless they have been given supervision
or instruction concerning use of the device by a person responsible for their
safety! Follow the instructions on Waste Electrical and Electronic Equipment
(WEEE) on page 38.
flow-med GmbH
Weinbergweg 10 73773 Aichwald Germany
Otoplastic AG Merkurstr. 4 9000 St. Gallen Switzerlan
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>