Alfatronix PR65R-AC Rail USB Power Supply User Guide
- June 13, 2024
- Alfatronix
Table of Contents
OPERATING & ASSEMBLY
INSTRUCTIONS
PR65R—RAIL USB Power Supply
SAFETY
- The device must not be exposed to severe mechanical shocks.
- The device must not be exposed to extreme temperature, direct sunlight or vigorous vibration.
- The device may only be used within a dry environment, such as a vehicle.
- Do not spray liquid in front of the USB connector.
- Do not install this device in the proximity of hot vehicle parts.
- The wiring harness should be protected by fuses.
- Observe the magnitude and polarity of the input voltage when installing, incorrect polarity of the input could damage the circuit.
- Isolate the circuit before you connect or remove the device.
- Never open the device casing and never repair it. The device must be replaced if it is damaged.
◼ FUSING
Each PR65R must be fused individually: 12/24V input voltage = 2A fuse
CONTENTS
◼ PACKING CONTENTS
i/iii. PR65R -C/-AC;
-
1 x USB Charger, 2 x Crimp Connectors, 1 x Standard Ring, 1 x Nut , 1 x Washer
ii/iv. PR65R -CFf/-ACFf; -
1 x USB Charger, 2 x Crimp Connectors, 1 x Bezel Back, 1x Bezel Ring, 3x Screws
ASSEMBLY
◼ ASSEMBLY (PR65R)
- Isolate the circuit before you connect or disconnect the device.
- Choose a suitable mounting surface ensuring nothing behind can be damaged, then drill a Ø30mm hole.
- Choose installation method, either; Standard Ring (i/iii) or Front fitting (ii/ iv).
- Connect input positive to the terminal indicated +, connect the input negative to the terminal indicated –.
i. PR65R –C/-AC;
- Press ‘Standard Ring’ over front of USB Charger, ensuring the slot is at the bottom.
- Insert body through the hole.
- Tighten the nut onto back of body ensuring front is aligned.
ii. PR65R -CFf/-ACFf;
- Place bezel over the USB Charger.
- Mark screw hole positions. Install through Ø30mm hole and screw into position.
- Press ‘Bezel Ring’ over front of the USB Charger, ensuring the slot is at the bottom.
INFORMATION
◼ FEATURES
- 12V & 24V systems compatible (9-32Vdc)
- 5Vdc output voltage
- Apple and Android auto-detect
- Supplied with FASTON crimp connectors
◼ TECHNICAL DATA
Part Number| Outputs| Current| Input
Voltage| Output
Voltage| Dimensions| Weight| IP
Rating
---|---|---|---|---|---|---|---
PR65R-C| 1| 2.5A| 9-32Vdc| 5Vdc| 037x50mm| 28g| IP65
PR65R-AC| 2| 3.6A| 9-32Vdc| 5Vdc| 037x49mm| 38g| IP65
◼ RING REMOVAL**
- Insert screwdriver in slot under USB Charger.
- Twist screwdriver to remove ring.
T E L: +44 (0) 1202 715 517
sales@alfatronix.com
Documents / Resources
|
Alfatronix PR65R-AC Rail USB Power
Supply
[pdf] User Guide
PR65R-AC Rail USB Power Supply, PR65R-AC, Rail USB Power Supply, USB Power
Supply, Power Supply, Supply
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>