TRIOBIKE Boxter Mid Drive Seat Instruction Manual
- June 13, 2024
- TRIOBIKE
Table of Contents
BOXTER SEAT ASSEMBLY INSTRUCTIONS
ENGLISH V 1.1
2 KIDS SEAT KIT PARTS
NEEDED TOOLS
|
---|---
1- Hex key, sizes: 3, 4, 5 mm| 2- Wrench, sizes: 10 mm
ASSEMBLING THE SEAT
ALL PICTURES SHOW 4 KIDS CONFIGURATION
-
Mount the brackets on the box, using 2xM4 bolt for each bracket, in the positions shown above. ONLY FOR REAR SEAT: mount a bracket in the middle of the box rear wall, upside down compared to the other brackets (use the bolts and nuts from the steering column).
USE A TORQUE OF 5 Nm MAX.
-
Connect seat belt shoulder holders to the rear wall on the box with 2xM5 bolt each in the specific threaded holes.
USE A TORQUE OF 5 Nm MAX.
-
Connect seat belt bottom parts to the box floor, using 1xM6 bolt each in the specific threaded holes.
-
Remove the protectors from the Velcro strips on the backrest rear side.
-
Place the backrest on the box, as shown on picture. Apply some force so that the Velcro adheres.
-
Place the seat on the brackets, aligned with the Velcro, and push so that the Velcro adheres.
TRIOBIKE A/S
Vesterbrogade 149, 1620 Copenhagen V – Denmark
phone: +45 3670 0070
info@triobike.dk
www.triobike.com