BFT A.15 O. PF UNI photocells with LED light Instructions
- June 13, 2024
- BFT
Table of Contents
BFT A.15 O. PF UNI photocells with LED light Instructions
Installation Instruction
OPERATING AND INSTALLATION INSTRUCTIONS
Thank you for choosing this product. The Firm is confident that its performance will meet your operating needs. Carefully read the “Instruction booklet” that comes with this product as it provides important information regarding safety, installation, use and maintenance. This product meets recognized technical standards and complies with safety provisions. We hereby confirm that it is in conformity with the following European directives: 2006/95/EEC, 2004/108/EEC. This is a type D device in accordance with EN 12453 and it will only be in conformity with directive 2006/42/EEC provided it is connected to a control panel from the same manufacturer equipped with a test circuit that looks for faults in the safety circuits.
WARNING:
- when carrying out connection and installation operations always refer to the current legislation in force, as well as to good technical principles.
- making changes to the device or to the unit’s configuration without consul- ting the manufacturer may result in hazardous situations.
- To connect the relay contacts to the fault test circuit, you must refer to the wiring diagrams of the tested devices given in the instruction manual for the control unit being used.
- if other devices using infrared beams (photocells) are present, they may cau- se interference.
USINGTHE DEVICE
Keep areas that lead to the safety device clear of obstacles. More
specifically, make sure that no branches or shrubs break the beam emitted by
the transmitter. If the safety device is triggered, no resetting or re-
enabling is required since the gate’s regular operation will be restored
automatically.
MAINTENANCE AND SCRAPPING
When the device is connected to a control panel from the same manufacturer,
provided with a fault-finding circuit in safety circuits, it requires no
maintenance, since testing is carried out automatically with each mano euvre
(test intervals conforming to risk analysis or EN12453). In the case where the
fault-finding circuit in safety circuits is not used, get qualified personnel
to check the device function at intervals not longer than 6 months. The
materials making up the appliance and its packing must be disposed of
according to current regulations. In case of malfunction, request the
assistance of qualified personnel. All adjustments, whether mechanical or
electrical, must be carried out by authorized personnel only in accordance
with the safety rules and instructions issued by the manufacturer. If
excessive amounts of dirt build up on the surface of the photocell, clean the
photocell lenses with a cloth.
SCRAPPING Materials must be disposed of in accordance with the
regulations
in force. Do not throw away your discarded equipment or used batteries with
household waste. You are responsible for taking all your waste electrical and
electronic equipment to a suitable recycling centre.
WARNING! Correct operation is only ensured when the data contained in the present manual are observed. The company is not to be held responsible for any damage resulting from failure to observe the installation standards and the instructions contained in the present manual. The descriptions and illustrations contained in the present manual are not binding. The Company reserves the right to make any alterations deemed appropriate for the technical, manufacturing and commercial improvement of the product, while leaving the essential product features unchanged, at any time and without undertaking to update the present publication.