SHARP PJ-TA181 Electric Fan Instruction Manual
- June 13, 2024
- Sharp
Table of Contents
SHARP PJ-TA181 Electric Fan
WARNING
- Never connect the plug with your wet hand as it may be dangerous from electric leakage.
- Should not use the electric fan close to curtain, Mosul net or any objects which could be pulled to the motor, otherwise this may cause accident and damage.
- Should not use the electric fan at the high temperature place such as placing tt close to the stove or the high humidly place, as the unit might be damaged.
- Should not place the electric fan on the honor sloped floras the unit might be damaged.
- Do not immerse the electric fan in water or sprinkling water because this could lead to a short circuit or equipment broken. s Do not insert the finger or any object through the grille while the blade is rotating.
INSTRUCTION FOR USE
1 Do not Strays any vapor or chemicals to the electric fan while the blade is
rotating. s Do not use the electric fan with incomplete or broken.
- Plug in tightly in order to avoid the plug to be overheated. This can cause the plastic to be melted. and conflagrated. When unplugging. hold on the plug part: do not pull the cable as this may cause the cable broken.
- If the electric fan is wrong operating. never repair by yours For safety and efficient use. contact your nearest service center approved by SHARP.
- If the power cord or plug is damaged. The power cord must be replaced by the manufacturer, its aftersales service or similarly qualified persons in order to avoid a hazard.
- Unplug every time before start to clean the parts or when you do not use the electric fan anymore.
- Never share the wall outlet with other appliances.
- Children should oo supervised to ensure that they do not play with the appliance.
- This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
DESCRIPTION OF PARTS
SPECIFIC INFORMATION
Detail is subject to change without prior notice.
ASSEMBLING THE ELECTRIC FAN
Installation the body onto the base.
WARNING
Do not switch on the electric fan unless the base is assembled (as the unit
might fall and cause injured.
Base
Thread the cord through the back and press the safety lock to the fan base,
and then insert the cord into the safety lock at the fan base.
BLADE AND GRILLE ASSEMBLING PROCESS
Dissembled the front grille to the mortise at the rear grille.
Splice and press both grilles together.
Push the locking armlock.
HEIGHT ADJUSTMENT
The height can be adjusted to 5 level
- Level up by press and hold the lock slide shaft and at the same time, lift the motor unit or slide shaft up.
- Level down by push the motor unit or slide shaft down.
WARNING DO not press down while not assembled the grille.
USE INDICATION
Be sure that the rated voltage is 220V only before use.
- Plug in tightly.
- Push the switch for the desired fan speed.
Swing control)
- Push the knob : the unit swings left and right.
- Pull the knob : the unit stop swinging.
(S wing drection)
Press or push the motor unit up or down.
Push the motor unit to the left or right direction in 5 strokes.
To store the cord, roll the cord around the cord storage at the back of the fan .
CLEANING AND MAINTENANCE
- Unplug every time before start to clean the part. Blade, front grille and rear grille
- Remove and wipe with damp cloth with water then dried up with the cloth.
- Me with damp cloth using water or mild soapy liquid.
- Be careful with water entering the electric parts or metaremark
Remark
- Be careful with water entering the electric parts or meter.
- Avoid using clean with chemical substance, alcohol. Thinner and kerosene e1c, as this might damage the surface and shape of unit.
THAI CITY ELECTRIC co., LTD.
3111CaJI center o 2254 5000 O www.sharp-weeclub.com