PROMAX VAN RYSEL Road Mechanical Disc Brake Instructions
- June 13, 2024
- PROMAX
Table of Contents
PROMAX VAN RYSEL Road Mechanical Disc Brake
Product Information
The Road Mechanical Disc Brake is a braking system designed for road bicycles. It provides reliable and efficient braking performance, allowing riders to have better control and stopping power.
Product Features:
- Easy installation and adjustment
- Smooth cable movement for optimal performance
- Barrel adjuster for fine-tuning brake feel
- Pad adjustment for proper pad clearance
- Durable construction for long-lasting use
INSTALLATION STEPS
STEP 1
-
Install the brake cable into the brake lever following the manufacter’s intructions.
-
Install end caps on each end of the brake housing and thread on to the brake cable. Ensure the cable moves smoothly with no binding.
CAUTION : Brake cable binding must be corrected before proceeding with the installation. Check for crushed cable ends, housing or cable kinks, or frayed cable housing strands that touch the cable. -
Route cable and housing to the brake caliper and into the barrel adjuster. Thread cable under cable anchor plate, pull taugt and tighten cable anchor bolt to 6Nm. Do not trim excess brake cable yet.
STEP 2
- While squeezing brake lever, tighten brake caliper bolts to 6Nm.
- Using a 5mm hex wrench, turn inboardpad adjustement 90 degrees counter-clockwise. This allows for proper pad clearance.
- Spin the wheel to make sure it spins freely. If the brake pads rub the rotor surface, use the pad adjustement to position the pad correctly.
- With bike on work stand, rotate the wheel and apply brakes. Rotate barrel adjusters to obtain preferred brake feel. Release the brake lever and spin wheel again to ensure the brake pads do not drag against the rotor. Adjust inboard pad clearance if necessary.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>