GORILLA LADDERS GLMPXT-FTW-2 Multi Position Ladder MPXA Wheel Kit Instructions
- June 12, 2024
- GORILLA LADDERS
Table of Contents
GORILLA LADDERS GLMPXT-FTW-2 Multi Position Ladder MPXA Wheel Kit
Instructions
OPERATING & SAFETY INSTRUCTIONS
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS MAY RESULT IN INJURIES OR DEATH.
SAFETY INSTRUCTIONS
-
Gorilla Ladders® multi-position wheel kit must only be used with the
MPXA and MPXT series multi-position ladders. -
Wheels must only be used to transport the ladder.
-
Wheels should never make contact to any surface when using the ladder or when adjusting the ladder. The ladder may roll out and cause injury or death.
-
When using the multi-position in the extension mode, the wheels must always be at the top of the ladder.
PARTS
WH UST M B NLY O D SE UE ANSPORT TR TO DDE A E L TH R.
AL R NEVE HE T OW L S EEL WH MAKE O T CT T A NT CO NY O A FACE WHEN SUR THE G
IN US R ADDE L ILE ADJ WH OR TING US DDE A E L TH R. DDE A E L TH AY MR OUT LL
RO ND CA A SE U Y INJUR ATH DE OR .
S EEL WH E ST B U M T THE T A T F O OP HE W DDER LA HEN HE T N I EXTENSI SI O
ON P TION.
LAS RUEDAS SOLO PUEDEN USARSE PARA TRANSPORTAR LA ESCALERA. NUNCA PERMITAS QUE
LAS RUEDAS ENTREN EN CONTACTO CON NINGUNA SUPERFICIE AL USAR LA ESCALERA 0
CUANDO ESTES AJUSTANDOLA. DE LO CONTRARIO, LA ESCALERA PUDIERAN PROVOCAR
LESIONES 0 MUERTE. LAS RUEDAS TIENEN QUE ESTAR EN LA PARTE SUPERIOR DE LA
ESCALERA AL USARSE ESTA EN LA POSICION DE EXTENSION. 161655A
TOOLS REQUIRED
QUESTIONS, PROBLEMS, OR MISSING PARTS?
If any parts are missing, damaged, or if you have any questions or need
additional instructions, visit us at www.gorillaladders.com to complete the
replacement parts submission form or call our customer service department at
1-800-867-6763. 9 a.m. – 4 p.m., CST,
Monday-Friday.
REMOVE OLD FEET
STEP : 1
Extend the outer sections of the multi-position ladder to gain easier
access to the feet rivets.
Locate the flanged side of the rivet.
STEP : 2
Using the drill and drill bit, put light pressure on the rivet to remove
the flange of the rivet. Repeat this process on both sides.
STOP DRILLING IMMEDIATELY ONCE THE FLANGE IS REMOVED.
CAUTION: Rivet might get hot while drilling.
STEP 3
Remove the old rivets using a punch and silde off the old feet.
INSTALLATION OF NEW FEET
STEP : 1
Slide the new feet onto the rail.
NOTE: Replacement feet with wheels must be on the same outer rail.
STEP : 2
Install the bolts, washers and lock nuts. Tighten all bolts securely.
STEP : 3
Attach the wheel warning label to the outer rails above each wheel.
Please reference figure for proper placement.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>