NURZVIY B0BPHJ7V7H EV Charger User Manual
- June 12, 2024
- Nurzviy
Table of Contents
B0BPHJ7V7H EV Charger
User Manual
Installation and Charging
Installation Instructions
Step 1
Drill holes with the help of the drilling template.
drillingtemp|ate with screw position ana punching size
Step 2
Hammer the M4.0 expansion tube into the wall hole.
Step 3
Remove the template from the wall.
Step 4
Use the screwdriver to fix the M4.0 tapping screws to the backplane on the
wall. Step 5
Install the plug holder with 3 M5x40 screws in an appropriate place.
Step 6
Install the charger on the backplane on the wall.
Step
7
Lock the anti-theft screw on the top of the charger and place the plug seat in
an appropriate place.
Step 8
Tear off the surface protective film of the charger.
Wire Connection Instructions
Through Power Distribution Box (Optional):
Drill holes with the help of the drilling template.
Through Joint:
Use the heat shrinkable waterproof joint to connect both ends.
- Be sure that L, N and PE ends should be corresponding respectively.
- Squeeze the joint with crimping pliers to ensure good contact.
Charging Instructions
-
Insert the charging input to the power supply.
-
Insert the charging plug to the charging port.
-
Start by swiping card.
-
EV is in normal charging state.
-
Finish by swiping card.
-
Remove the charger and put it back in place.
Warning:
Nurzviy EV charger is a continuous load device. The circuit must be rated for
125% of the maximum load
Circuit Rating | Max Load | Estimated Range per Hour | Plug-in | Hardwire |
---|---|---|---|---|
40A | 32A | 25 miles/40 km | yes | optional |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>