BURG Master Pro Hidden RFID Lock User Manual

Master Pro
Operating Manual

Master Pro

Front view

A button 4
B button 3
C button 2
D button 1
E LED
F battery compartment
G hole for fixing screws

Introduction

The Master Pro is the invisible electronic furniture lock that can be used wirelessly in drawers, compartments, cupboards, singleleaf hinged doors, sliding doors and wooden roller blinds and many other non-metallic materials.
The locking system is particularly suitable for installation situations where the appearance of surfaces should not be disturbed by a lock. The lock is simple and easy to install – without milling or drilling through the front.
Importante notes:

• Observe all instructions and read through the entire
  manual before you start the configuration.

• The lock is not suitable for installation in steel furniture.

• Before you start configuration and assembly, check the battery capacity (p. 4, „Battery warning“).

•  Note that the reset button is located on the rear side of the lock and can only be operated when the lock is disassembled.

General

The latest version of this guide is available at:
www.burg.de

Factsheet

Technical Data

locking)
Material| Housing: plastic Locking bolt: acrylic and steel
Locking direction| L, R
Lock attachment| Screws, Adhesive pad
Door thickness| max. 25 – 30 mm
RFID type| MIFARE® Classic (13,56 MHz)
Manager Cards| max. 3
Master Cards| max. 3
User Cards| max. 30
Delete Cards| max. 7
Break-off point| 30 N
Default Settings

Mode| Multi User Mode
Signal tones| On

Scope of Delivery

•  1x locking system
• 1x battery compartment cover (incl. screw)
•  1x transponder card (MIFARE® Classic, 13,65 MHz)
•  1x strike plate
•  4x fixing screws (locking system)
•  2x fixing screws (strike plate)

Features

•  versatile and flexible installation options
•  not visible on the door front
•  proven RFID technology (MIFARE® Classic, 13,65 MHz)
• up to 30 transponders can be assigned per lock
• simple configuration and programming
•  operates reliably at temperatures from 0°C to 40°C
• handy size (61 x 61 x 22 mm) and simple mounting

Product Dimensions

Functional Description

Mode 1: Multi User Authorization (Multi User Mode)
This mode is suitable for constantly changing users who use the locker only temporarily or once, e.g. in a sports facility. Transponders are valid for a single locking operation and are deleted by the lock when the compartment is opened again so that a new  ransponder can be used. The bolt remains open until a new transponder locks the lock again. Before locking, the door must be closed (lightly pressed). The user holds the transponder medium centrally in front of the lock. The lock locks. The LED starts to flash. The lock can then only be opened with the same transponder medium.
Mode 2: Fixed Assigned Authorization (Private Mode) with Automatic Locking
In this mode, a transponder medium is preset with which the lock can be operated. This mode is suitable for user groups where the user rights are not to change permanently, e.g. in an office cabinet. The lock can be opened and closed with any stored transponder medium. Transponder media that are not stored are rejected by the lock. The user holds the transponder medium centrally in front of the lock to open the lock. The lock locks automatically after 5 seconds. The door must be pushed shut within 30 seconds after the opening process.
Note: If the door is not closed during this time, an alarm sounds for 10 seconds.
Mode 3: Fixed Assigned Authorization (Private Mode) with Manual Locking
In this mode, a transponder medium is preset with which the lock can be operated. This mode is suitable for user groups where the user rights are not to change permanently, e.g. in an office cabinet. The lock can be opened and closed with any stored transponder medium. Transponder media that are not stored are rejected by the lock. The user holds the transponder medium centrally in front of the lock to open the lock. The lock must be closed again manually. To close it, the user must again hold the transponder medium centrally in front of the lock.
Master Card
The Master Card opens the lock independently of the set mode (emergency opening) and terminate the block mode. The lock remains in the open state after opening. In Multi User Mode, the transponder used for locking is deleted from the lock.
Manager Card
In the private modes (modes 2 and 3), the Manager Card can be used to assign transponder media. In Multi User Mode (mode 1)*, the Manager Card can open the lock temporarily (for example, during maintenance or content check) without deleting the used transponder from the lock. Previously assigned transponders can still open the lock.
Delete Card
The delete card can be used to delete transponder media from the lock. In Private Mode, all stored transponder media are deleted when the delete card is presented. In Multi User Mode, the delete card can delete the transponder used for closing when the lock is in the closed state.
Automatic Locking (Private Mode)
After opening, the lock locks automatically after 5 seconds. The door is closed by pressing lightly. This function applies to the private mode with automatic locking (mode 2).
Note: If the door is not closed during this time, an alarm sounds for 10 seconds.
Manual Locking
To lock the lock, the user must press the door slightly closed and hold an authorized transponder centrally in front of the lock.
This function applies to Multi User Mode (mode 1) and Private Mode with manual locking (mode 3).
Signal Tones
Signal tones sound during the opening or closing process and when unauthorized transponders are presented.
Block Mode (Private Mode)
If an unauthorized transponder is held in front of the lock 5 times, the lock blocks for 60 seconds. During the locking period, the lock rejects all transponders by emitting a signal tone and lighting up the red LED. The locking mode can be cancelled by holding the manager card in front of the lock.
Status Alarm (Private Mode)
If the lock in Private Mode with automatic locking (mode 2) is not closed within 30 seconds after opening, a 10-second alarm will sound. This function can be switched on or off by pressing programming buttons 1 and 2 simultaneously.
Occupied Identification
The lock is in the Multi User Mode described above. However, the transponder used for locking is assigned a occupied identification so that it cannot lock any more locks. The occupied identification is canceled again during the opening process.
Battery Warning
If the battery capacity falls below a certain limit, the blue LED lights up when a transponder is presented and an signal tone sounds 8 times. If the critical range is reached, the lock can no longer be locked or can only be opened with the Master Card.

Assembly Instructions

Configuration

1. Change Mode
   The lock has three different modes (see functional description).
   Starting from the default setting (Multi User Mode), the modes are set as follows:
   1. Press the programming button 3 for two seconds.
   2. Confirmation of the successful process by flashing of the green LED and subsequent signal tones:
   • Two signal tones when changing from mode 1 (default setting) to mode 2.
   • Three signal tones when changing from mode 2 to mode 3.
   • One signal tone when changing from mode 3 to mode 1.
   Note: assigned transponders are deleted when the modes are changed.

2. Assign cards and transponders
   Function cards and transponder media are set by pressing the corresponding programming buttons.
   a) Assign Master Card
   1. Press the programming button 4 for two seconds.
   The green LED starts flashing.
   2. While the green LED is flashing, hold the Master Card to be assigned in front of the lock.
   3. A beep confirms the successful operation.
   4. If required, hold further Master Cards to be assigned in front of the lock one after the other (max. 3).
   b) Assign Manager Card
   1. Press the programming button 1 for two seconds.
   The green LED starts flashing.
   2. While the green LED is flashing, hold the Manager Card to be assigned in front of the lock.
   3. A beep confirms the successful operation.
   4. If required, hold further Manager Cards to be assigned in front of the lock one after the other (max. 3).
   c) Assign Delete Card (only for mode 2 and 3)
   1. Press the programming button 2 for two seconds.
   The green LED starts flashing.
   2. While the green LED is flashing, hold the delete card to be assigned in front of the lock.
   3. A beep confirms the successful operation.
   4. If required, hold further delete cards to be assigned in front of the lock one after the other (max. 7).
   d) Assign Transponders (only for mode 2 and 3)
   1. Hold manager card in front of the lock.
   The green LED starts flashing.
   2. While the green LED is flashing, hold the transponder to be assigned centrally in front of the lock.
   3. A beep confirms the successful operation.
   4. If necessary, hold additional transponders to be assigned one after the other in front of the lock (max. 30).

3. Delete Transponder
   To delete the transponders, hold the delete card in front of the lock. All assigned transponders are deleted from the lock.

Operation

1. Multi User Mode
   a) Lock
   Push the door slightly, hold the transponder and wait until the lock has locked.
   b) Unlock
   Hold the transponder in front of the lock and wait until the the lock has unlocked.
   2 Private Mode
   a) Unlock
   Hold the transponder in front of the lock and wait until the the lock has unlocked.
   b) Lock (mode 2)
   The lock closes automatically after 5 seconds. Push the door slightly closed within 30 seconds.
   Note: If the door is not closed during this time, an alarm sounds for 10 seconds.
   c) Lock (mode 3)
   Push the door slightly, hold the transponder and wait until the lock has locked.

Battery Replacement

The battery compartment is located on the front side of the lock and is accessible even when mounted. The battery is changed as follows:

1.  Loosen the screw of the battery cover and remove the battery cover.
2.  Remove the empty battery and insert the new battery.
3. Close the battery compartment and fix it with the screw.

Important: The battery should be replaced immediately after the first battery warning (p. 4). If the battery capacity reaches the critical range, the lock can no longer be locked and can only be opened by the Master Card.

Reset to Default Settings

To reset the lock to the factory settings, the reset button on the back of the lock must be pressed. All stored settings and all assigned cards will be deleted from the lock.
Important: The reset button is located on the back of the lock and can only be operated when the lock is disassembled.

Disposal and battery note

EU Directive 2012/19/EU regulates the proper take-back, treatment and recycling of used electronic equipment.Every consumer is required by law to dispose of batteries, accumulators or electrical and electronic equipment („waste equipment“) powered by batteries or accumulators separately from household waste, as they contain harmful substances and valuable resources. Disposal can be done at a collection or take-back point approved for this purpose, e.g. a local recycling center. Waste equipment, batteries or rechargeable batteries are accepted there free of charge and recycled in an environmentally friendly and resource-saving manner. Waste equipment, used batteries or rechargeable batteries can also be returned to us. The return must be sufficiently stamped to the address below. The following symbol on the waste electrical equipment, batteries or accumulators indicates that they must not be disposed of with household waste:
Caution when using batteries!
The battery may explode or release flammable gases if it is mishandled, destroyed, or the wrong type of battery is used. Do not recharge the battery, disassemble it, expose it to extremely high temperatures or throw it into a fire.
On batteries containing harmful substances, you will find indications in the form of abbreviations for the ingredients cadmium (Cd), mercury (Hg) and lead (Pb) in each case.

BURG F. W. Lüling KG
Volmarsteiner Str. 52
58089 Hagen (Germany)
Fon + 49 (0) 23 35. 63 08-0
info@burg.de
www.burg.de
Master Pro | 07-2022
Image rights: cover image, wood texture, BURG F .W. Lüling KG
Rev. 04

References

• Home - BURG

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>