Govee H601B WiFi Bluetooth RGBWW Downlight User Manual
- June 12, 2024
- Govee
Table of Contents
- Govee H601B WiFi Bluetooth RGBWW Downlight
- Safety Instructions
- At a Glance
- Specifications
- Installing Your Device
- Pairing Your Downlight with Govee Home App
- Customer Service
- FCC Statement
- FCC Radiation Exposure Statement
- IC Statement
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Govee H601B WiFi Bluetooth RGBWW Downlight
Safety Instructions
Read and follow all the safety instructions:
- The down light is not waterproof. Avoid exposing it to splashes or water drops.
- The operating temperature should be within -10° to 40°c (14° to 104°FJ.
- The downlight internal light source is unfixable. If it breaks, the entire downlight must be replaced.
- Do not allow children to install the down light.
- External dimmers cannot be used with this product.
- Installation and maintenance should be operated by a professional.
- Avoid installing the downlight near heat sources or in damp locations.
- Avoid installing the downlight near potentially dangerous sources (e.g., candles, liquid-filled objects).
At a Glance
Thanks for choosing Govee Smart LED Down light. This product can be quickly connected to your smartphone in just a few steps. You can change its color, set timers, and DIV your own lighting scenes.
Specifications
- Working Voltage AC 1 00V-240V
- Power 11W
- Lumen 850Im
- Color Temperature 2700K~6500K
- Working Temperature -10°c to 40°C/14°F to 104°F
- Color RGBWW
Installing Your Device
Press down the spring loaded clip firmly into the spring groove at the bottom of downlight. After installation, the spring loaded clip will be difficult to pull out.
Unplug the device from power before installation.
Place the template and trace it with a pen, then cut the hole in the ceiling.
Open the hardwire box swing cover. Push open the round hole on the side by a tool. Using wire terminals, connect green ground wire of cable to green ground wire of box, so are the white wire and the black wire.
Connect the fixture to the hardwire box and Insert it through the mounting hole. Push spring loaded clips on the fixture upwards and insert fixture base in to the mounting hole, then release the clips.
Notice
- Make sure the distance between the devices and the router is less than 100ft.
- Keep as few obstructions (e.g. wall, windows) as possible between the devices and the router.
Pairing Your Downlight with Govee Home App
What You Need
- A Wi-Fi router supporting the 2.4GHz and 802.11 b/g/n bands. 5GHz is not supported.
- A smartphone or tablet running iOS 8.0 (or above) or Android 4.3 (or above).
Customer Service
Warranty: 12-Month Limited Warranty
Support: Lifetime Technical Support 9
Email: support@govee.com
Official Website : www.govee.com
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning : Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio on technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.”
This Class B digital apparatus complies with Canadian ICES-005.