Arlux LIGHTING ARA 3297027600581 Rechargeable Light Instruction Manual
- June 12, 2024
- Arlux LIGHTING
Table of Contents
ARA
Instructions for use
ARA 3297027600581 Rechargeable Light
Electrical products must not be thrown out with domestic waste.They must
be taken to a communal collecting point for environmentally friendly disposal
in accordance with local egulations. Contact your local authorities or
stockist for advice on recycling. Batteries must be recycled or disposed
of in an appropriate manner. Do not dispose of batteries in household garbage,
municipal waste or on fire, as they may leak or explode. Do not open, short
circuit, or damage the batteries, as this may cause injury.
**** Product conforms to European Union Directives
Class Ill, equipment supplied at a voltage of less than 50 volts
General safety instructions
- Check that the product is not damaged before handling. Switch off the product before handling.
- Do not expose the product ta strong heat. Do not throw in fire
- Do not look directly at the light source.
- Regularly clean the product using a soft, slightly damp, lint-free cloth.
- Before first use, fully charge the battery.
- Do not leave the charger plugged in indefinitely after the battery has been fully charged.
- Batteries should not be opened, destroyed or incinerated as they may leak or rupture and release toxic gases and chemical compounds. Do not throw into fire.
- Do not expose the batteries close to heat sources.
- Do not store the product in a damp or wet place, or in a place where the tempera
- ture is likely to reach or exceed 40°C. For example, in an outdoor shed, vehicle or sheet metal building during the summer.
- Do not use or dispose of the product in water or any other liquid.
- The battery of this product is replaceable by a professional or qualified person.
- Use a battery of the same type and specifications.
- Take care to respect the charging current and voltage.
- Battery life may vary depending on the light intensity chosen.
- For good detection, make sure the sensor is clean
Switch on the device. Then hold your hand in front of the sensor for a long
time to increase or decrease the light intensity Test the detection distance
before final installation.