CRYSTAL QUEST CQE-CT-00142 Countertop Thunder Reverse Osmosis System User Guide

June 12, 2024
CRYSTAL QUEST

CRYSTAL QUEST logo Crystal Quest®
Countertop Thunder®
Reverse Osmosis System
INSTALLATION AND OPERATION GUIDECRYSTAL QUEST CQE CT 00142 Countertop
Thunder Reverse Osmosis System ONLINE WARRANTY INFORMATION
CrystalQuest.com/warranty.html Copyright 2023
Crystal Quest®
All rights reserved
MADE IN THE USA

INSTALLATION INSTRUCTIONS

Remove red cap. Follow the instructions below to install your countertop system.

  1. Remove the aerator from faucet.

  2. Determine the need for an adapter.
    Choose cor rect adapter as needed.
    CRYSTAL QUEST CQE CT 00142 Countertop Thunder Reverse Osmosis System -
system

  3. Attach the diverter to the faucet and turn until tight.
    CRYSTAL QUEST CQE CT 00142 Countertop Thunder Reverse Osmosis System -
diverter

  4. Use the la rge clamp to tighten unit hose to the faucet.
    CRYSTAL QUEST CQE CT 00142 Countertop Thunder Reverse Osmosis System -
faucet

CRYSTAL QUEST CQE CT 00142 Countertop Thunder Reverse Osmosis System -
Countertop

Countertop Thunder® RO System
1-Diverter
2-Tubing
3-Pre-treatment cartridge (activated cartridge)
4-Auto shut-off valve
5-Membrane
6-Post-treatment cartridge
7-Spout
8-Drain line/flow restrictor
9-Pre-filter (optional)
OPERATING SPECIFICATIONS:

Pressure Range:| 45 psi and up
Temperate Range:| 40°-85° F (4.4-29.4°C)
Optimum Service Flow:| 0.30 gpm at 60 psi

CARE AND OPTIMUM USE

  1. Use COLD water only. Do not use on hot water. This may damage the cartridges.
  2. The contaminants or other substances removed or reduced by this water filter are not necessarily in all users’ area.
  3. Soak the diverter in a vinegar and water solution once a month. This will clean deposits that form from feed water and help prevent corrosion of internal diverter mechanisms

TROUBLESHOOTING

  1. Low water pressure or no water flow. Very low water temperatures may cause water flow through membrane to slow or stop. Wait for temperature to rise.

  2. High levels of hardness in feed water. A crystallized layer may form around membrane in feed water with high levels of hardness, causing water to flow improperly.
    Soak membrane invinegar and water solution for 2 to 3 hours to clean membrane. Rinse thoroughly before using.

  3. Exhausted filter cartridges. Exhausted cartridges may clog. If steps above do not bring results, filters should be changed.

IMPORTANT INFORMATION

Your Countertop Thunder™ Reverse Osmosis Water Filter system cartridges must be replaced at regular intervals to maintain proper performance.CRYSTAL
QUEST CQE CT 00142 Countertop Thunder Reverse Osmosis System -
performance

  • The filter cartridges have a limited service life.* Use only factory approved cartridges.
  • Changes in taste, odor, and flow of the water being filtered indicate that cartridges should be replaced.
  • Do not use non-Crystal Quest® replacement cartridges.
  • Do not use non-Crystal Quest® parts or modify/tamper with unit.

*Life of the cartridge varies with water consumption and water condition

CHANGING MEMBRANE

1. Loosen the connector fitting counter clockwise.|

1. Loosen the connector fitting counter clockwise.

| 3. Remove the membrane with a  pincer.| 4. Insert the membrane by carefully pushing the spigot end  into the socket at the far end of the housing until completely  sealed.| 5. Wr ap the connector fitting with thread seal tape and connect it to a new cartridge.
---|---|---|---|---
| | | |

PRE-FILTER INSTALLATION

CRYSTAL QUEST CQE CT 00142 Countertop Thunder Reverse Osmosis System -
inlet

  1. Remove the water inlet elbow from pre-treatment cartridge by turning counterclockwise (Fig 2).
  2. Thread male end of pre-filter (Fig 1, #9) into pre-treatment cartridge (Fig 1, #3) and tighten clockwise. You may need to use thread seal tape.
  3. Thread previous elbow (Fig 2, #3). Thread tape may be needed.
  4. Turn on water supply and run for 2 minutes prior to first use.

QUICK-FITTING

CRYSTAL QUEST CQE CT 00142 Countertop Thunder Reverse Osmosis System -
fitting

  1. Remove security lock from quick fitting (Fig A).
  2. Push and hold collect against body while pulling tube out (Fig B).
  3. Remove and throw away the used cartridge.
  4. Insert the new filter cartridge in the clips.
  5. Push the tubing through collet until it seals firmly at bottom of quick fitting (Fig C).
  6. Put the quick fitting security lock back.
  7. Turn on water and check for leaks.
  8. Flush 4-5 gallons of water through filter before use.

ONE-YEAR LIMITED WARRANTY

CRYSTAL QUEST® warrants your CRYSTAL QUEST® Thunder™ Countertop Reverse Osmosis Water Filter for one year from the date of purchase against all defects in material

Product design is subject to change without notice.
For further assistance, contact your Crystal Quest dealer or visit us at www.crystalquest.com
To view the latest edition of the Countertop Thunder® Reverse Osmosis System Guide, visit CrystalQuest.com
Please note all drawings, pictures, colors and sizes are approximate for illustrative purposes only and may not exactly resemble the end product.

CQE-CT-00142CRYSTAL QUEST CQE CT 00142 Countertop Thunder Reverse
Osmosis System - Bar CodeCRYSTAL QUEST logo

Documents / Resources

| CRYSTAL QUEST CQE-CT-00142 Countertop Thunder Reverse Osmosis System [pdf] User Guide
CQE-CT-00142 Countertop Thunder Reverse Osmosis System, CQE-CT-00142, Countertop Thunder Reverse Osmosis System, Thunder Reverse Osmosis System, Reverse Osmosis System, Osmosis System
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

CRYSTAL QUEST User Manuals

Related Manuals