colebrook bosson saunders FLX/018/C07 Flo X Top Mount Clamp Instruction Manual
- June 12, 2024
- colebrook bosson saunders
Table of Contents
colebrook bosson saunders FLX018C07 Flo X Top Mount Clamp
PARTS INCLUDED
INSTALLATION INSTRUCTIONS
-
POSITION CLAMP PLATE ONTO WORK SURFACE
-
CONFIGURE FOR WORK SURFACE THICKNESS
-
FITC -BRACKET
IMPORTANT NOTE
Ensure inside of bracket is flush against back of work surface -
FIT CLAMP SCREWS
-
FULLY TIGHTEN SCREWS
-
CONFIGURE 180 ° STOP ( ifrequired )
A 180° STOP ENGAGED
B 360° ROTATION
-
FIT CLAMP COVER AND BUSH
WARNING
- Do not use this product for any purpose other than that for which it was designed
- Ensure desk/work surface is suitable to take the weight of the arm/s and monitors
- Supported weight must not exceed the maximum load per arm
- Take care when installing as fingers could become trapped
MAINTENANCE AND INSPECTION
- Ensure all screws are tightened and occasionally adjust if needed
- Ensure arm is pushed fully down onto the clamp before installing the monitor(s)
- Clean with a damp cloth, NO solvents
DISCLAIMERS
- The use of power tools, lever bars or excessive force during the installation, or re-configuration of the product will invalidate your guarantee
- Failure to observe the recommendations in the use, and configuration of these products may affect your guarantee
- As a part of Colebrook Bosson Saunders ongoing product improvement programme the design of products may change without prior notice and details may vary from those illustrated
PATENTS
Colebrook Bosson Saunders hold a number of patents and other intellectual
property rights covering our products and processes.
You can find patent information on our website at:
www.colebrookbossonsaunders.com/patents
Please consider leaving these instructions with the product if further installation may be required by others
FLX-018-C07-INST-A-SEPT-2022
colebrook
bosson saunders
