Shanghai TanYuan Trading Co Ltd RT81 Remote Control Instructions
- June 12, 2024
- Shanghai TanYuan Trading Co Ltd
Table of Contents
TanYuan Trading Co Ltd
RT81 Remote Control Instructions
Remote Control
Working Mode
The supporting remote control operates in a three-button mode. Three buttons
on the remote are respectively used to control the gate opening, closing, and
stopping functions. The fourth button has no function.
Wireless Keypad Pairing
- Remove the motor casing, and open the cover of the control board box.
- Locate the learning button AN1 on the control board and press it.
- Check if the remote control indicator LED2 on the control board lights up.
- Press the same button on the remote control twice.
- Observe if the remote control indicator LED2 blinks a few times and then turns off.
- This indicates that the learning of the remote control is complete.
- You can learn up to 25 remote controls.
Delete Paired Remote Control
- Remove the motor casing, and open the cover of the control board box.
- Locate the learning button AN1 and hold it down.
- Check the remote control indicator LED2 on the control board lights up and holding until it turns off.
- Release the learning button, and the learning code for the remote control has been successfully deleted.
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
FCC ID: 2BCCM-RT81
Model: RT81