Verkada ACC-MNT-XLARM-1 Large Arm Mount Installation Guide
- June 12, 2024
- Verkada
Table of Contents
**Verkada ACC-MNT-XLARM-1 Large Arm Mount Installation Guide
**
What’s in the box
ACC-MNT-XLARM-1
Closure Plug (1 pcs) (Attached to mount)
Hex keys (2 pcs) 3mm and 5mm
1/4”-20 Sleeve Anchors (4 pcs) Length: 2-3/4” Drill Size: 5/16″}
M8 Machine Screws (4 pcs) Length: 20mm Drive: 5mm hex
What you’ll need
- A compatible Verkada product
- A hammer drill
- A 5/16” masonry drill bit
- A 7/16” or adjustable wrench
- A ½” (12.7mm) drill bit, or larger, for routing cable through wall
Compatible products
For a list of compatible products,
please visit:
https://docs.verkada.com/docs/accessories-overview.pdf
Installation Wiring
Wiring through a wall Drill a ¼” hole for the Ethernet cable to feed through.
The mount can accept cable entry through the back.
Wiring through the opening
If wiring through the ¾” NPT* opening at the base, remove the closure plug
Attach a standard ¾” NPT conduit fitting
*(USA) National pipe taper
For Concrete or Masonry
Mark the 4 pilot hole locations. Holes should be at least 4” from wall edges
or corners. Drill 5/16” pilot holes at least 2-3/4” deep
using a hammer drill and impact-rated masonry bit.
After drilling, clear dust and debris from hole.
Mount by pressing the sleeve anchors into the pilot holes. Make sure the washer and nut are tight against the accessory body. To secure, set the anchors by turning 3 to 4 full turns, using a 7/16” wrench.
For Pole or Corner Mount
Attach Large Arm Mount to hole pattern 1 of Corner Mount or Pole Mount using
the included machine screws.
To secure, tighten the machine screws, using the provided 5mm Hex key
Securing device to mount
Use the internal 1.5” NPT threads to screw the Pendant Cap onto the Large Arm
Mount.
After attaching the Verkada device to the mount, tighten the set screw with the provided 3mm Hex key.
Please see additional install steps for the device you are mounting in its
respective Install Guide.
Support
Thank you for purchasing this Verkada product. If for any reason you’re experiencing issues or need assistance, please contact our 24/7 Technical Support Team immediately.
Sincerely,
The Verkada Team
verkada.com/support
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
[email protected]
All specifications are subject to change without notice © Copyright 2023
Verkada Inc. All rights reserved.