Verkada ACC-MNT-POLE-1 Pole Mount Installation Guide
- June 12, 2024
- Verkada
Table of Contents
Verkada ACC-MNT-POLE-1 Pole Mount Installation Guide
What’s in the box
-
ACC-MNT-POLE-1
-
M4x0.7 Machine Screw (4 pcs) Length: 14mm Drive: #2 Phillips
-
Small Pole Straps (2 pcs) Range: 48-107mm Drive: #2 Phillips
-
Temporary Zip Tie (1 pcs) Maximum Diameter: 218mm (8.6”)
-
Large Pole Straps (2 pcs) Length: 84-178mm Drive: #2 Phillips
What you’ll need
- Compatible Verkada product
- A #2 Phillips screwdriver or power drill with a #2 Phillips driver bit
- 1/2 inch (12.7mm) drill bit, or larger, for routing cable through wall
- Utility knife
Compatible products
For a list of compatible products, please visit: https://docs.verkada.com/docs/accessories-overview.pdf
Hole Patterns
- CD/CF series, Verkada mounts
- CB series
- CM series
- ACC-CAM-SHIELD-1
- ACC-MNT-XLARM-1
Mounting on a small pole
For poles with diameter of less than 3.2” (81 mm). A zip tie is provided to aid in the install process. Make sure to remove it once installation is completed.
Position the Pole Mount in the desired location.
Route the temporary zip tie through the top, front slot and around the pole.
Route a small pole strap through the bottom, front slot and around the pole. Tighten with a #2 Phillips head screwdriver or drill bit.
Remove the temporary zip tie with a utility knife and repeat the former
installation step on the top, front slot.
Secure the mount to the pole by tightening the pole straps.
Once complete, mount a compatible Verkada product onto the Pole Mount.
See the install guide of your compatible Verkada product for further mounting
instructions.
For poles with diameter of more than 3.2” (81 mm).
A zip tie is provided to aid in the install process. Make sure to remove it once installation is completed.
Position the Pole Mount in the desired location.
Route the temporary zip tie through the top, side slots and around the pole.
Route a large pole strap through the bottom, side slots and around the pole. Tighten with a #2 Phillips head screwdriver or drill bit.
Remove the temporary zip tie with a utility knife and repeat the former
installation step on the top, side slots.
Secure the mount to the pole by tightening the pole straps.
Once complete, mount a compatible Verkada product onto the Pole Mount.
See the install guide of your compatible Verkada product for further mounting
instructions.
Appendix Support
Thank you for purchasing this Verkada product. If for any reason you’re experiencing issues or need assistance, please contact our 24/7 Technical Support Team immediately.
Sincerely,
The Verkada Team
verkada.com/support
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401 sales@verkada.com
All specifications are subject to change without notice
© Copyright 2023 Verkada Inc. All rights reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>