tp-link EAP610-Outdoor AX1800 WiFi 6 Dual Band WIFI Access Point Installation Guide

: June 12, 2024
: tp-link

Table of Contents

tp-link EAP610-Outdoor AX1800 WiFi 6 Dual Band WIFI Access Point
Typical Network Topology
Hardware Connection
Hardware Installation
Software Configurations
- References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

tp-link EAP610-Outdoor AX1800 WiFi 6 Dual Band WIFI Access Point

Installation Guide

tp-link EAP610-Outdoor AX1800 WiFi 6 Dual Band WIFI Access
Point.webp

Note: The image may differ from the actual product

Typical Network Topology

■ Managed Mode
Via Centralized Management Software

FIG 1 Managed Mode.JPG

A computer running the centralized management software, which can be in the same or different subnet with the APs, is used to centrally manage the APs.

You can get the corresponding software from our website http://www.tp- link.com.
Via Hardware Controller (for Omada APs)

FIG 2 Managed Mode.JPG

The hardware controller can be in the same or different subnet with the APs. The management host is used to log in to the hardware controller to centrally manage the APs.

■ Standalone Mode

FIG 3 Standalone Mode.JPG

Hardware Connection

Choose a method to connect your device according to the accessories.

■ Via PoE Switch
Some APs can be powered via the PSE device (such as a PoE switch) which complies with Power Source Class 2 (PS2) or Limited Power Source (LPS) of IEC 62368-1.

Note: Availability depends on the actual product. Please refer to the product specifications.

FIG 4 Via PoE Switch.JPG

■ Via PoE Adapter
Some APs can be powered via the PoE adapter.
Note: Availability depends on the actual product. Please refer to the product specifications

FIG 5 Via PoE Adapter.JPG

FIG 6 Via PoE Adapter.JPG

Hardware Installation

1. Choose a method to mount the device.
■ Mounting the Device on a Pole
At the selected site, attach the device to a suitable point of the pole and then approximately align the device to the direction that you have oriented.

FIG 7 Hardware Installation.JPG

■ Mounting the Device on the Wall (for the product with mounting brackets)

Mount the mounting bracket to the preferred position in the wall. Push and slide the device to lock it into place. Then connect the antennas to the device.

2. Install the waterproof seal. (For certain devices)

Before installing, fit the Ethernet cable through the spiral cover, bracket, and O-ring. Then follow the steps as shown in the picture:

Connect the Ethernet cable to the port.
Fit the O-Ring to the head of the bracket, and screw the bracket to the body of the device.
Fit the Ethernet cable through the seal’s slit with the thicker side towards the bracket.
Plug the seal to the bracket.
Screw the spiral cover to the bracket.

Software Configurations

■ Managed Mode
To configure mass devices via a centralized management software or a wireless controller, please refer to the corresponding User Guide. You can download the
User Guide from our website http://www.tp-link.com.

■ Standalone Mode
To configure a device through a web-based management system, please follow the steps below.

Launch a web browser and enter the IP address of your device in the address bar and press Enter.
Note:
For Omada APs, you can check the IP address through the product label.
For other products, the default IP address is 192.168.0.254 and the IP address of your computer should be set as 192.168.0.x (“x” is any number from 1 to 253).
Enter admin for both User Name and Password for login.
Change the default User Name and Password to protect your device, then start configuring the device.

FIG 10 QR CODE.JPG