Koolatron BF01 Bark Free Pro Indoor Training Device User Manual
- June 12, 2024
- Koolatron
Table of Contents
BARK FREE™
ANTI – ABOIEMENTS™
DIRECTIONS FOR USE
Free Pro Indoor Training Device
User Manual BF01
FUNCTIONS
- Up to 30 ft. radius coverage area
- 50 ft. outdoor power extension cord
- Twin dual piezo-ceramic transducers
- 1 year limited warranty
DIRECTIONS FOR USE
MOUNTING LOCATIONS
The best place to position the Bark Free system is slightly above and
facing the dog. The Bark Free will detect barking up to 30 feet away, so mount
the unit for dogs within 30 feet. Be sure that your dog(s) cannot reach the
unit to prevent damage. Keep extension cords out of reach. The Bark Free can
be mounted or placed free-standing in the desired location. If using indoors,
place Bark Free in a room where the dog is often known to bark.
NOTE: If you place the unit in a room and your dog is in another room,
Bark Free can be effective but results may not be as significant.
MOUNTING OUTDOOR
Bark Free is weather resistant, but not waterproof. Direct exposure to
water will temporarily reduce the sensitivity of the microphone and speakers.
Outdoors, Bark Free may be triggered by loud sounds other than barking. Try to
avoid mounting in damp and high wind areas. If water enters the unit through
the speaker holes, lay the unit down to allow water to drain out. If the unit
stops working when wet, it will resume operation when dry. The unit includes
mounting slots and screws for fastening unit to a building or post. BARK
PICK-UP SENSITIVITY ADJUSTMENTS
This adjustment allows you to control how loud the bark must be to trigger the
correction tone, while reducing any false triggering. Make this adjustment on
a calm day if the system is mounted outdoors.
To adjust the sensitivity, first set the audible sound selector (located above
the sensitivity switch) to audible. This lowers the correction tone frequency
so that you hear the tone. Move away from the unit and listen. If you do not
hear the tone each time you hear barking, adjust to the higher sensitivity
level, or move the unit closer to the dog. If you hear the tone without
hearing the barking, adjust to the lower sensitivity level. Larger dogs react
better to lower tones while smaller dogs have a better reaction to higher
tones. When you have the sensitivity adjusted, reset the switch to
“ultrasonic” (if desired). Use the lowest possible sensitivity setting that
will respond consistently to barking. If it is set too high, other sounds may
trigger the unit.
The “Novel Stimulus” aspect of the tone will then be lost and your dogs will
learn to ignore Bark Free. Also be sure that the background noise level is not
too high or it will cause continued triggering. You can correct this by
reducing the sensitivity level.
NOTE: DO NOT try to instigate barking from your dog to find out if Bark
Free will stop them from barking. A dog will always bark if harassed.
TEST BUTTON
Pushing the test button will lower the ultrasonic frequencies to an audible
human level. This way you can hear the different ultrasonic features. To avoid
hearing damage, do not use the Test button for long periods of time and do not
allow children to play with the test button.
POWER
The Bark Free uses (4) “D” size alkaline batteries (not included). Batteries
last approx. 2000 sound releases under normal conditions.
The Bark Free can also be powered by a 6V center pin (+) DC adapter, included.
Use the 50’ extension cord if needed, also included.
NOTE:The transformer case is not weather resistant and must be plugged
indoors if not using a weather resistant outdoor case. A protected casing is
available at your local hardware store.
IMPORTANT NOTE: Human reinforcement is suggested for this unit to be more
effective.
TO INSTALL BATTERIE
- Turn knob on batter cover counter clockwise.
- Remve battery cover.
- Insert 4 “D” batteries in the correct orientation.
- Replace knob and turn clockwise.
There is also an input jack for the power adapter. It is located on the back
on the left side of the unit, protected by a plastic plug.
AC adapter specifications: 200mA/DC 6V (not included). Please contact your
local dealer or purchase directly from Koolatron by calling
407-857-8786, toll free at
800-265-8456 or Koolatron on the web at
www.koolatron.com.
WHAT RESULTS TO EXPECT
There are no 100% perfect cures that stop 100% of the barking, this includes
the Bark Free.
Within a week or two, if you haven’t noticed a significant reduction in the
overall amount of barking, especially at night, then you have a more serious
problem than just simple unnecessary nuisance and boredom barking. A dog will
always bark if harassed. Some of the more severe problems include:
- PROTECTIVE BARKING: They may bark at trespassers or neighbors that tease or threaten them. This may include people knocking at your door or people walking through your yard.
- DOGS TRAINED TO BARK: They may inadvertently be trained to bark, by receiving attention (both positive and negative) for barking.
- FEEDING TIME AND WORK TIME BARKING: We recommend that you disconnect Bark Free when feeding. When walking one dog and leaving others behind, get out of sight as soon as possible.
- HEARING PROBLEMS: Deaf dogs will not react to Bark Free. Dogs with high frequency hearing damage may react to the audible setting. However, you and your neighbors may hear it.
- HIGH STRESS ENVIRONMENTS: Bark Free is not recommended for boarding kennels, animal shelters, and grooming salons. These locations generate protective and fear barking.
WARRANTY
This KOOLATRON product is warranted to the retail customer for 90 days from
date of retail purchase, against defects in material and workmanship.
WHAT IS COVERED
- Replacement parts and labour.
- Transportation charges to customer for the repaired product.
WHAT IS NOT COVERED
- Damage caused by abuse, accident, misuse, or neglect.
- Transportation of the unit or component from the customer to Koolatron.
IMPLIED WARRANTIES
Any implied warranties, including the implied warranty of merchantability are
also limited to the duration of 90 days from the date of retail purchase.
WARRANTY REGISTRATION
Register on-line at www.koolatron.com AND keep the
original, dated, sales receipt with this manual.
WARRANTY AND SERVICE PROCEDURE
If you have a problem with your BF01, or require replacement parts, please
telephone the following number for assistance:
North America 1-800-265-8456
The Service Advisors will advise you on the best course of action. Koolatron
has Master Service Centres at these locations:
Koolatron U.S.A.
4330 Commerce Dr.
Batavia, NY 14020-4102 U.S.A.
Canada
Koolatron Canada
27 Catharine Ave
Brantford, ON N3T 1X5
A Koolatron Master Service Centre must perform all warranty work.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>