Bestway P5535 LED Strip Light Owner’s Manual
- June 12, 2024
- Bestway
Table of Contents
Bestway P5535 LED Strip Light Owner’s Manual
Assembly Instruction
SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS – READ AND FOLLOW ALL INSTRUCTIONS.
Warning – Do not connect the chain to supply while it is in the packing
or wound onto a reel. Do not use the chain when covered or recessed into a
surface. Do not open or cut the chain. The external flexible cable or cord of
this luminaire cannot be replaced; if the cord is damaged, the luminaire shall
be destroyed. The light source of this luminaire is not replaceable; when the
light source reaches its end of life the whole luminaire shall be replaced. Do
not connect this chain electrically to another chain. The lamps are not
replaceable.
SAVE THESE INSTRUCTIONS.
WARNING
IMPORTANT: Do not put the Remote Control in the water, if the remote
control falls into water, take it out of the water immediately. Damage to the
remote control caused by immersion in the water is not covered under your
warranty.
Battery Precaution
- Do not mix old and new batteries.
- Do not mix the different types of batteries. Do not mix alkaline, standard (Carbon – Zinc), or rechargeable (Nickel – Cadmium) batteries.
- Ensure batteries are installed correctly with regard to polarity (+ and -).
- Do not short-circuit the battery.
- Never attempt to recharge primary batteries as this may cause leakage, fire, or explosion.
- Rechargeable batteries are to be removed from this product before being charged.
- Never attempt to disassemble or open batteries as this can lead to electrolyte burns.
- Remove batteries from equipment which is not to be used for an extended period of time.
- Exhausted batteries are to be removed from this product.
- Do not dispose of product and its batteries in fire. Check your local regulations for proper disposal instructions.
- Batteries shall not be exposed to excessive heat such as sunshine, fire or the similar.
- Keep batteries out of the reach of children.
- Only use 2x CR2032 batteries.
Parts reference overview
LED strip , 433.92MHz
LED Remote Control , 433.92MHz, -10dBm
DC output transformer. Output:12VDC,1A
Software Version:
CPU-SOP8-64A8/B637 for LED strip
CPU-SOP14-3F2A(8586) for Remote Control
Follow the instructions to straighten the strip before installing to the SPA.
ATTENTION: DO NOT TWIST OR THE STRIP COULD BREAK
ATTENTION: DO NOT PULL THE STRIP FROM THE CONNECTION
WARNING: THIS ROPE LIGHT MUST NOT BE USED WITHOUT ALL GASKETS BEING IN
PLACE.
©2022 Bestway Inflatables & Material Corp.
All rights reserved
Trademarks used in some countries under license from
Bestway Inflatables & Material Corp., Shanghai, China
Manufactured, distributed and represented in the European Union by
Bestway (Europe) S.r.l., Via Resistenza, 5, 20098 San Giuliano Milanese
(Milano), Italy Distributed in Latin America by
Bestway Central & South America Ltda, Salar Ascotan 1282, Parque Enea,
Pudahuel, Santiago, Chile
Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit
2/98-104 Carnarvon St Silverwater, NSW 2128, Australia
Tel: Australia: (+61) 2 9037 1388; New Zealand: 0800 142 101
Bestway (Hong Kong) International Ltd./Bestway Enterprise Company Limited
Suite 713, 7/Floor, East Wing, Tsim Sha Tsui Centre, 66 Mody Road, Kowloon,
Hong Kong
www.bestwaycorp.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>