FENIX APEX 20 Limited Edition Flashlight Instruction Manual
- June 4, 2024
- FENIX
Table of Contents
FENIX APEX 20 Limited Edition Flashlight
FENIXAPEX20 FLASHLIGHT
- 760 lumens maximum output, 86 maten; maximum beam distance 0 U988 a Cree XP-L HI V2 white light LED and a Crea XQ-E red light LED, with a lifespan of 50,000 hours.
- Built-in 500mAh Li..polymer battery.
- White and red light sources.
- USB Type-C charging port.
- Duel-way operation with the side round rotating switch.
- Boot-up battery level Indication and low-voltage water,.i.
- Made ofTC4 titanium alloy.
- Size: 2.77” x 1.12″x 0.54″ / 70.4 x 28.5x 13.7 mm.
- weight 2.15 w:/61 g.
OPERATING INSTRUCTION
ON/OFF
Rotate the side switch forwards or backward to tum on the flashlight, and
rotate it again in oppooite direction to tum off the light.
Mode Switching
With the light switched off, rapidly rotate the switch forwards to enter white
light mode, rotate 1he switch backward to tum off the light. After the light
Is being switched over 0.6 seconds, rapidly rotate the switch backwards to
enter red light mode, rotate the switch forwards to
tum olflhe light tly rotate the switch lo tum on the light for Note:
preventing It is needed accidental ID acylation. instant
Output Selection
White light mode: Rapidly rotate the switch forwards to cycle -through
OFF a± Eco a± Low a± Med a± High a± Turbo.
Red light mode: Rapidly rotate the switch backwards to cycle through
OFF a± Low a± Med a± High.
CHARGING
- Rest switch off 1he light and reveal the USB Type-C charging port and plug the USB A sort of Ille triaging cable Into an elecb1cal outlet, 1hen connect 1he USB Type-C socket of 1he charging cable to the light.
- The indicators will display in the tum while enlarging and will be constant on when fully charged.
- Once charging Is completed, be sure to replace the anti-dust cap to
TECHNICAL PARAMETERS
Note: According to lo the ANSI/PLATO FL 1 standard, Iha above specifications are from the results produced by FeniK lhl’OIJ9h its laboratory testing using 1he built-in 50llmAh Li-polymer ball under the temperature Df 21±3’C and humidity of 50% – 80%. The true performance of this product may vary according to to > different working arrvironrnent& and the actual battery used. “The Turbo output Is measured In II total Df runtime Including output at reduced level11 due to temperature or protection mechanism n the design.
-
Note: The normal Merging Hm,o Is approximately 2 hour Imm depletion to full
-
charging. Recharge a stored lour months lo maintain the optimum
perfonnance of the battery. odes em both evellllble white -
charging, Low but mode the or whtto charging light time end will lJ.e red light prolonged. m
BATTERY LEVEL INDICATION
- With the light switched off, rotate the ewrtch, the indicators will indicate the battery level and will last for 3 seconds.
- Four blue lights an: saturated 100%- 80%
- Three blue lights en: sufficient S0¾ -80%
- Two blue lights on; relatively sufficient 60% – 40%
- One blue light on: poor 40% – 20%
- One blue light flashes: critical 20% -1%
INTELLIGENT OVERHEAT PROTECTION
The light will accumulate e lat of heat when used at relatively high modes
for extended periods. When the light reaches e temperature of 60″C or above,
the light will automatically at ep down a few lumen to reduce the temperature.
When the temperature drops below 60″C, it will then allow the uaer to reselect
the modes.
LOW-VOLTAGE WARNING
When the voltage level drops below the pr&Elet level, the fleshlight le programmed to downshift to a lower brightness level until Law output is reached. When this happens in Low output, one battery level indicator constantly bl Inks blue to remind you to recharge the battery.
USAGE AND MAINTENANCE
- Dlsessembllng the sealed head can cause damage to the light and will void the warranty.
- Any problem encountered during use, please contact your author1zed dlstr1butor.
INCLUDED
Neck Fenix APEX lanyard, 20 User Flashlight, manual, USB Warranty Type-C card charging cable, Key chain,
WARNING
-
The flashlight Is a high-lntenalty lighting device capable af causing eye damage to 1he user or ethers. Avoid shining 1he light directly into anyone’s eyes.
-
This flashlight will accumulate a lot af heat when used for extended periods, resulting in a high temperature of the flashlight shell. Pay attention to safe use to avoid sceldlng.
(\I Do not shine an object at close range, to avoid burning the object or causing danger due to high temperature. -
The LED of this flt111hlight is not replaceable: so the entire light should be replaced when the LE□ reaches the end of Its nre
-
If any of the information provided in this manual is changed, the new version of the manual shall prevail; if your included user manual is an old one, it acquiesces that we won1 send a new manual.
LIGHTING FOR EXTREMES
“Follow” us for more information about Fenix.
FENIXLIGHT LIMITED
Tel: +86-755-29631163/83/93 Fax: +86-755-29631181
E-mail: [email protected]
Address: 2F/3F, West of Building A, Xinghong Technology Park, 111 Shuiku Road,
Fenghuanggang Community, Xixiang Street, Bao’an District, Shenzhen City,
Guangdong Province, China
Web:www.fenixlight.com