Levi 7749 Downlighter Instruction Manual
- June 12, 2024
- Levi
Table of Contents
Levi 7749 Downlighter Instruction Manual
Downlighter
Levi Downlighter Matzwart – 7749 | Levi Downlighter Antraciet – 7750 | Levi
Downlighter Messing – 7751 | Levi Downlighter Verzinkt – 7752
Assembly and installation instructions
- The light fitting must be installed by a qualified electrician. The main supply must be disconnected at the fuse box before starting installation. Before starting with installation, use a voltage tester to make sure the wiring is off circuit. You also need to ensure that in relation to the earthing on the electrical lead the local regulations are observed.
- Remove the front of the lamp of the installation base. Drill holes in the wall. Then insert the plugs. Put the cable from the wall through the hole (pierced in the rubber) in the installation base. Screw the installation base on the wall
- Then led the wires to the luster terminal. Connect the wires from the wall to the connector block. Attach the wires, and keep the correct colors in track: Blue lead = Neutral (N) Browner Black lead = Live (L) Yellow/Green lead = Earth (not on class II light fittings) Note that: the(brown) wire L1 corresponds to the mains cable L (or the connector L), the (blue) wire N1corresponds to the neutral conductor N (or connector N), the (yellow / green) wire 1corresponds to the earth cable (or luster terminal ) Prevent humidity on all components. Make sure there is a watertight seal.
- Make sure you put a light bulb corresponding to the type and wattage as indicated on the packaging. Tighten the screws after placing well.
- Switch on the main supply. The light is now ready for use.
Maintenance requirements: It is recommended that the surface is rubbed regularly with a neutral oil or water without cleaning agents and then wiped with a soft cloth. Keep the armature free from a salty environment, coastal location and an acid free environment, this affects the armature. Rub it regularly with Carwash, it ensures a longer lifetime of the armature. In case of damage or fracture of the protective glass, replace the glass directly to insure the IP value. Make sure when replacing the lamp that the power is off and the lamp has cooled down.
The drawings are for illustrative purposes only. They may vary in model of the lamp
www.ks-verlichting.nl
December 2021
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>