DVIGEAR DN-300-RMKV SDVoE AV Over IP Transmitter Instruction Manual
- June 12, 2024
- DVIGEAR
Table of Contents
DVIGEAR DN-300-RMKV SDVoE AV Over IP Transmitter
Product Information
The product is a rack mount bracket model DN-300-RMKV. It is designed to be used for vertical rack mounting of the DN-300 device. The bracket has been revised by L. Barlow Flournoy on 12.JAN.2023, with a revision number of 1.0. The drawing number for the bracket is 12012023-DN-300-RMKV-01-LBF. The approval for the revision was given by S. Barlow on the same date.
Product Usage Instructions
- Ensure that you have the DN-300 device and the DN-300-RMKV rack mount bracket.
- Identify the front and rear views of the bracket.
- Use the silkscreen indications on the bracket to determine the mounting positions based on the number of units to be mounted.
- Align the DN-300 device with the bracket, ensuring that the necessary ports and connectors are accessible.
- Securely attach the DN-300 device to the bracket using the provided screws and captive screws.
- If required, connect any necessary cables or wires to the ports and connectors of the DN-300 device.
- Place the assembled DN-300 device and bracket in the desired location within the rack.
- Ensure that the bracket is securely fastened to the rack, following any additional instructions provided by the rack manufacturer.
- Verify that all connections are properly made and that the DN-300 device is functioning correctly.
- If necessary, repeat the above steps for additional DN-300 devices and brackets.
Note: The above instructions are a general guide. Please refer to the specific DN-300-RMKV user manual for detailed installation instructions and any additional precautions or requirements.
DIMENSION
| page 1/3 | |
|---|---|
| MODEL NUMBER | |
| DESCRIPTION | DisplayNet® SDVoE Transmitter / Receiver, Rack Mount, Front |
View
REVISED BY| L. Barlow Flournoy| 12.JAN.2023| DRAWING
NUMBER| 12012023-DN-300-RMKV-01-LBF
APPROVED BY| S. BARLOW| 12.JAN.2023| REVISION| 1.0
NOTES: Ratio is 1:2. Actual dimensions shown in red. All measurements shown are in millimeters. Rack mount bend setback is depicted in grey.
NOTES: Ratio is 1:2. Actual dimensions shown in red. All measurements shown are in millimeters.
NOTES: Ratio is 3:10. Silkscreen indicates positions for brackets based on number of units mounted (6/1, 6/2, 6/3, etc.).
NOTES: Ratio is 3:10. Silkscreen indicates positions for brackets based on a number of units mounted (8/1, 8/2, 8/3, etc.).
NOTES: Ratio is 3:10. Silkscreen indicates positions for brackets based on number of units mounted (10/1, 10/2, 10/3, etc.). © 2023 DVIGear, Inc. All Rights Reserved
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>