Current IS Series LED Luminaire Endcap Installation Guide
- June 12, 2024
- current
Table of Contents
Current IS Series LED Luminaire Endcap
Product Information
The Endcap Cover Accessory IS Series is an accessory designed for use with the IND190 product. It consists of two end caps, one female end cap (A) and one male end cap (B). These end caps are not identical and have different clipping fixtures on each side.
Product Usage Instructions
- Identify the female end cap (A) and the male end cap (B) based on the clipping fixtures.
- Push both end caps onto the fixture, ensuring that the female end cap (A) snaps on securely.
- For the male end cap (B), use two screws to secure it to the fixture.
- Repeat the above steps for continuous run installations.
Note : Ensure that the end caps are properly installed and secured to the fixture before proceeding with any further installation or usage.
For more information and support, please visit LED.com or refer to the product manual (Page 1 of 1, Rev 05/17/23) IND190 -LuminationISSeriesLEDEndcapAccessory-InstallationGuide_R01.
Lumination® LED Luminaire
Endcap Cover Accessory IS Series
INSTALLATION
- The end caps are not identical. The clipping fixture is a female at one side (A) and a male at the other side (B).
- Push both end caps onto the fixture. End cap A will snap on. End cap B will require two screws to secure.
NOTE : Follow a similar procedure for continuous run installations
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change without notice. All values are design or typical values when measured under laboratory conditions.
(Rev 05/17/23)
IND190 – Lumination IS Series LED Endcap Accessory – Installation Guide_R01
Installation Guide IND190 | 052715
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>