AVOSDIM MKENR_ALU Mosquito Blind Windows and Doors Instructions
- June 12, 2024
- AVOSDIM
Table of Contents
AVOSDIM MKENR_ALU Mosquito Blind Windows and Doors
COMPONENTS
INSTALLATION INSTRUCTION
-
Take two or three reference measurements.
-
Take the smallest dimension into account
-
Remove the end cap from the side where the scale is located. Cut the cassette to the required dimension (L – 9mm).
-
Mark and drill holes for your brackets, then screw fix.
-
Cut your side guides to the required height (H-41mm)
-
Pre-drill your side guides 50mm from the top, halfway down, and 50mm from the bottom.
-
Position your guide tracks by slotting them onto the cassette, marking where to drill. Remove the side guides and drill. Reposition and fix using the screws provided.
-
The mesh cloth doesn’t wind up: To tighten spring tension, unscrew the end cap on the spring side (non-graduated side) while holding it firmly. Turn the end cap with its spring several turns and screw it back on.
The mesh cloth doesn’t unwind:
- An out-of-square of the window reveal causes, without doubt, a narrowing. Recheck the width at 3 different points then cut the box again according to the smallest dimension taken.
- The handlebar should get a slight clearance to avoid intense friction against side guides (it damages the brush seals). Recut a few millimeters from it.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>