HOOVER CH54100V Commercial Bagged Task Vac Upright Vacuum User Guide
- June 12, 2024
- Hoover
Table of Contents
HOOVER CH54100V Commercial Bagged Task Vac Upright Vacuum
Product Information
Product Name: Upright Vacuum
Assembly:
Fully assemble the product prior to use.
- Push the handle into the body of the vacuum until it clicks into place.
Operation:
- Press the Power Button to turn ON/OFF.
Carpet Height Adjustment:
To adjust the height setting, push down and turn the knob to the desired
height setting. Turn the knob to the next higher setting.
Using Hose and Attachments:
- Make sure the vacuum is upright and press the hose release button to pull out the hose end.
- Remove the hose and attach the desired accessory. The Extension Wand can be added for additional reach.
Stair Cleaning:
Lift the vacuum by the stair cleaning handle and position it on the stairs.
Clean from forward to back. Never leave the vacuum unattended on the stairs.
Changing the Filter Bag – Part # AH10040:
- To change the filter bag, while pushing the door release button, pull the handle up and out.
- Place the bag door over a trash bin and push the lever to drop the filter bag into the trash bin.
- Slide the new filter bag’s cardboard sleeve into the bag holder so that the lever secures it.
- Replace the door by inserting the bottom first, then swing the top of the bag door in so it latches.
For further assistance, please call Customer Support at Dial:
- 1-888-768-2014 (M-F 8 AM – 4 PM CST).
- Product Manual Reference: 961003569-R0
- Visit HooverCommercial.com for more information.
CAUTION:
- CAUTION: NOT TO BE USED FOR GROOMING A PET.
- CAUTION: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS, UNPLUG BEFORE SERVICING.
- CAUTION: USE EXTRA CARE WHEN CLEANING ON STAIRS. TO AVOID PERSONAL INJURY OR DAMAGE, AND TO PREVENT THE CLEANER FROM FALLING, ALWAYS PLACE THE CLEANER AT THE BOTTOM OF THE STAIRS OR ON THE FLOOR. DO NOT PLACE CLEANER ON STAIRS OR FURNITURE, AS IT MAY RESULT IN INJURY OR DAMAGE. WHEN USING TOOLS, ALWAYS ENSURE THE HANDLE IS IN THE UPRIGHT POSITION.
ASSEMBLY
Fully assemble the product prior to use.
- Push the handle into the body of the vacuum until it clicks into place.
- Insert the hose into the hose port. It will click when secured.
OPERATION
- Press the Power Button to turn ON/OFF.
- Step on the handle release pedal and lean the handle back.
CARPET HEIGHT ADJUSTMENT
To adjust height setting, PUSH DOWN and TURN knob desired height setting.
For maximum cleaning performance, the following carpet height settings are recommended:
- Lowest setting (1): for bare floors
- Low setting (2): for all types of carpet
- Higher settings: for very deep pile carpet, where easier pushing effort is desired, while maintaining good cleaning performance.
IMPORTANT:
If the vacuum is difficult to push, push down and turn knob to the next higher
setting.
USING HOSE AND ATTACHMENTS
- Make sure the vacuum is upright and press the hose release button and pull hose end out.
- Remove hose and attach the desired accessory. The Extension Wand can be added for additional reach.
STAIR CLEANING
- Lift the vacuum by the stair cleaning handle and position it on the stairs, cleaning forward to back. Never leave the vacuum on the stairs unattended or not when cleaning.
CHANGING THE FILTER BAG-PART # AH10040
- To change the filter bag, while pushing the door release button, pull the handle up and out.
- Slide the new filter bag’s cardboard sleeve into the bag holder so the lever secures it.
- Replace the door by inserting the bottom first, then swing the top of the bag door in so it latches.
- Replace the door by inserting the bottom first, then swing the top of the bag door in so it latches.
NOTE:
Make sure the filter bag is tucked securely between the tabs on the bag door.
IMPORTANT:
Use only genuine HOOVER® bags with your vacuum.
HooverCommercial.com
©2022 Techtronic Floorcare Technology Limited
Dial: 1-888-768-2014 (M-F 8AM – 4
PM CST) to speak with a Customer Representative.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>