Current IND684 LDED Eco Disk Downlight Installation Guide
- June 12, 2024
- current
Table of Contents
Current IND684 LDED Eco Disk Downlight Installation Guide
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING/AVERTISSEMENT
Follow label information and instructions concerning Wet or Damp Locations, installation near combustible materials, insulation, building materials, and proper lamping. Do not install in areas subject to combustible vapors or gases. Before wiring to power supply and during servicing or revamping, turn off power at fuse or circuit breaker. All servicing or relamping must be performed by qualified service personnel. Product must be grounded to avoid potential electric shock or other potential hazard. _Product must be mounted in locations and at heights and in a manner consistent with its intended use, and in compliance with the National Electrical Code and local codes. _The use of accessory equipment not recommended by the manufacturer or installed contrary to instructions may cause an unsafe condition. Do not block light emanating from product in whole or part, as this may cause an unsafe condition. Do not allow items such as drapes, curtains, screens, or the like to come into contact with the product or to block light from the product, as this may cause an unsafe condition.
Save These Instructions
Use only in the manner intended by the manufacturer. If you have any
questions, contact the manufacturer.
Standard Installation
-
Rotate lens clockwise until tabs line up with slots and remove lens from fixture base.
-
Connect supply wire conduit to LED driver, make wire connections using wire nuts:
Black →Line (Hot) White→Neutral Green→Ground Place LED driver and wires into J-box.
-
Using CCT switch, adjust fixture to desired color temperature.
-
Tighten J-box screws until the fixture base is secure and the bottom flange of the fixture is tight to the ceiling surface.
-
Align the tabs on the lens to the slots in the fixture base. Lock lens in place by turning counterclockwise until secure.
-
Ensure that the fixture is flush with ceiling surface.
Retrofit Installation into Existing Recessed Can using Accessory Kit
(Sold Separately)
-
Screw the provided connector into the socket inside of the can.|
-
Attach the orange terminal connector into the input lines 2 as shown.
-
Using CCT switch, adjust fixture to desired color temperature.
-
A : For 4” retrofit accessory kit, snap the provided mounting springs into place and ensure that they cannot be easily removed.
B : For 6” retrofit accessory kit, install bracket by pushing tabs into slot and rotating into place.
C : For 6” retrofit accessory kit, install bracket by pushing tabs into slot and rotating into place. For installation into a 6in can, turn brackets outward, as shown For installation into a 5in can, turn brackets inward, as shown. -
Connect the male and female orange connectors. Push the disk fixture into the existing can ensuring the wires are not pinched between the surface and the can.
-
Ensure that the fixture is flush with ceiling surface.
Current : 25825 Science Park : Beachwood : OH 44122
864-678-1000
© 2023 Current Lighting Holdco, Inc. All rights reserved. Information and
specifications subject to change
without notice. All values are design or typical values when measured under
laboratory conditions.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>