LEZNE Macro Drive 1400+ LED Bike Light User Guide
- October 31, 2023
- LEZNE
Table of Contents
LEZNE Macro Drive 1400+ LED Bike Light User Guide
MACRO DRIVE
READ ENTIRE MANUAL BEFORE OPERATION to ensure proper use and care of your new Lezyne LED light. Traffic laws mandating lighting vary from country to country. Inform yourself about lighting laws and regulations in the country of use. Lezyne LED lights do not conform to the German road traffic regulation StvZO.
MACRO DRIVE 1400+
Warnings
DO NOT LOOK DIRECTLY INTO LIGHT BEAM or shine into eyes of anothe.
Lezyne LED Lights have a water resistance rating of IPX7 under IEC standard
60529. Submerging the device is not recommended. If moisture does enter the
casing, air out until completely dry.
DO NOT ATTEMPT TO REMOVE ELECTRONICS. Doing so will void warranty.
Lezyne USA, Inc. does not accept any liability for injuries or other damages
resulting from the use of this product in any circumstances.
Mounting
Operation
- On/Off: hold button two (2) seconds.
- Mode cycle: click button
The light is now in Race Mode where only Overdrive and Economy outputs are
selectable. The light will remain in Overdrive Race Mode even when switched
OFF. Repeat the step above to return to the normal mode set.
MODE MEMORY: The light remains in the output setting it is switched OFF
in,
THERMAL PROTECTION: If the operating temperature of the light is too
high, the light automatically lowers the lumen output.
Run Times
MACRO DRIVE 1400+
| Economy 200LUMENS| Enduro 450 LUMENS| Blast 950 LUMENS| Over Drive 1400 LUMENS| Day Flash 700 LUMENS| FEMTO 20 LUMENS| Pulse 100 LUMENS ---|---|---|---|---|---|---|--- | 25:00 h:min| 12:30 h:min| 4:00 h:min| 3:00 h:min| 100:00 h:min| 300:00 h:min| 14:00 h:min | | | | | | |
Battery Indicator
An LED, located in the button, displays current battery status while light
is ON. When light is OFF, click button once to momentarily display battery
status.
100% lluminates green
50% luminates yellow
10% Hlluminates red
5% Flashes red
Charging
Before using your Lezyne LED Light for the first time, fully charge the
battery. To charge your light
-
switch light OFF
-
Remove USB-C protective cover
-
Connect USB-C cable and light to powered USB-C port
-
Once charging, button will flash green; if USB-C port s capable, light will use High Efficiency (HE) charging and button will flash blue.
If button does not flash when plugged in, selected USB-C port may not be powered—try another USB-C port.
Light will be charged after 5-6 hours (3-5 with HE charging) or when button illuminates solid green or blue. -
Remove light from charger and reinstall USB-C protective cover—ensure USB-C protective cover is fully installed for water resistance.
Charging Full Green
Fully Charged llluminates green
USB-C Cable Not Included
Charging Flashes blue
Fully Charged llluminates blue
Warranty
InU.S. and U.K., Lezyne LED Lights carry a two (2) year warranty from the
original purchase date to the original owner (proof of purchase required).
Lezyne Batteries carry a six (6) month warranty from the original purchase
date. Lezyne warranties cover any manufacturing defects in materials or
workmanship. Issues not covered by warranty include normal wear & tear,
improper installation, attempting to access or modify electronics, damage or
failure due to accident, misuse, abuse and/or neglect. For all warranty issues
worldwide, please contact the retailer that sold the product.
For any warranty questions contact:
warranty@lezyne.com
