ENGWE RS6 Electric Bicycle User Manual

June 4, 2024
ENGWE

ENGWE-BIKES

|
---|---

Electric Bicycle
General Manual

Operation and maintenance manual
Before using the e-bike, please read the attached operating instructions. Carefully read the safety rules.

Safety Instruction

IMPORTANCE
When using the electric bicycle, basic safety precautions should always be followed, including the following:

  1. Read all instructions.
  2. To protect against fire, electric shock and injury to persons, do not immerse cord, plugs, or e-bike in water or other liquid.
  3. Close supervision is necessary when the e-bike is used by or near children.
  4. Unplug from outlet when not in charging and before cleaning.
  5. Do not operate the e-bike with a damaged cord or plug or after the e-bike malfunctions, or has been damaged in any manner. Take the e-bike to the nearest authorized service bike shop for examination, repair or adjustment.
  6. The use of accessory attachments not recommended by the e-bike manufacturer may result in fire, electric shock or injury to persons.
  7. Do waterproof when using on a rainy or snowy day.
  8. Do not let cord hang over the edge of table or counter, or touch hot surfaces.
  9. Do not place on or near a hot gas or electric burner, or a heated oven.
  10. Always attach the plug to the battery first, then plug the cord into the wall outlet.
  11. Do not use the bike for other than intended use.
  12. Save these instructions.

Read This First: Safety and Compliance with the Law
Congratulations on your purchasing of your new e-bike. Your new e-bike is an excellent piece of personal transportation equipment that will give you good service for many years.
Before you start using your e-bike, we want you to be aware of a few important points. Please read this section carefully.

  • Observe Laws Regarding the Use of Battery-Operated Bicycles
    Your e-bike is designed and manufactured to meet safety requirements as a battery-operated bicycle. However, state and local laws governing the use of battery-operated bicycles on public roadways, parks, and other open areas may differ. Please check with your local authority before using your e-bike in public areas.

  • Observe Laws Regarding the Use of Bicycles
    Note that all laws regarding the use of bicycles in public areas, such as those mandating the use of helmets and the use of infant seats, will automatically apply for e-bikes. Check with your local authority on what restrictions might apply.

  • The Lithium-ion Battery of Your e-Bike
    Your e-bike is equipped with the latest battery technology. The lithium-ion battery is much lighter than lead- or nickel-based batteries that are being used in some older models.

  • Your First Ride
    Please be VERY CAREFUL when you are ready to get on your e-bike for the first time because that the e-bike moves significantly faster than a regular bicycle at active power-assisted mode. Take your e-bike to an area with a lot of open space before you start. Do not start pedaling hard as soon as you get on the e-bike (as you normally would so with a regular bicycle), as the e-bike will accelerate under pedal-assist mode and you may be unprepared for the sudden increase in speed. However, after a few times, you will enjoy using the pedal- assisted function.

Bike Components

Name of main parts of electric bicycle

Technical Parameters

Main technical parameters of electric bicyle

vehicle parameters

LWH(in)| 500206.7402.4| front
brake| model| 160 disc brakes
body width (in)| 83.
form and method
of operation| disc type:
manual operation
front and rear wheel center distance (in)| 343.
hanger flat section maximum width (in)| 59.| rear
brake| model| 160 disc brakes
the maximum distance between
the outer sides of the two shanks (in)| 79.
form and method
of operation| disc type:
manual operation
saddle height (in)| 352.
overall saddle height (in)| 98.| front and
rear tires| specifications| front wheel: 142.125
rear wheel: 14
2.125
toe space (in)| 77.| factory fixed air
pressure (KPa)| Front Wheel: 250
Rear Wheel: 250
mass (lb)| 64.| frame| material| high-carbon steel
maximum design speed (mph)| 16.
headlight| model| MGQ-1| rear light| model| /
Motor and electrical system parameters
motor| model| GT-350W| battery| model| PACK- FST- 18650
type
lithium battery|
type| permanent magnet
nom nominal
voltage (V)| 48
rated voltage (V)| 48
capacity (AH)| 8
nominal power (V)| 350
total mass (LB)| 7.5
rated speed (r/min)| 380
charger| model| DZLS4830-03
controller| model| 48V6G
overcurrent protection value (V)| 15±2| converter| model| /
manufacturer| /
undervoltage protection value (V)| 38±2

Fault and Troubleshooting

Fault Description Fault Reason solution
Spccd rcw,ulalion tallurc ,-: speed below 6.2mph I. The battery voltage is

too low
2. The speed control lever is faulty
3. Transmission group failure| Fully charge the batter)
Motor hub does not work after power on| 1. The battery wiring is loose
2. The battery wiring plug is loose
3. The speed control lever is faulty| 1. Take out the battery box and reinstall it
2. Fasten the wiring plug
Insufficient cruising range after charging| 1. Insufficient tire pressure
2. Insufficient charging or faulty charger
3. The battery is aging or damaged
4. Uphill / headwind / heavy load / poor road conditions / low temperature| 1. Full of gas
2. Fully charge or check the charger
3. Replace the battery
4. It is recommended to use pedal assist
Charger not charging| 1. The plug is not inserted properly
2. The charger fuse is blown
3. The battery pack fuse is blown| 1. Fasten the socket
2. Replace the fuse
The battery is fully charged but no voltage is displayed, the motor hub is difficult to start| 1. The voltage is lower than 30V when starting the electric hub
2. The battery switch wire falls off
3. The monitor patch cord is loose
4. Controller failure| 1. Replace the battery with a new one
2. Reconnect/tighten
After opening the electric door lock, it is found that the signal part is normal and the driving part is abnormal| 1. Battery undervoltage
2. The left and right brake levers are damaged
3. The controller or motor is damaged
4. Line abnormality
5. The speed control handle is damaged or the circuit is abnormal| 1. Replace the speed control handle and overhaul the circuit
2. Timely charging
3. Replace the left and right brake levers
4. Replace the controller or motor
Abnormal zero start mode (switch left and right position)| 1.The start mode switch or speed control handle is damaged
2. Line abnormality| Replace damaged parts/repair wiring
Non-zero start mode exception (switch is in themiddle)| 1. The starting mode switch is incorrectly selected or the booster is dama edg
2. Line abnormality| Check switch position/replace booster/repair circuit

If the product has problems with the following forms during the protection period, we will provide customer service as part of the product quality guarantee.

Accessories| Quality problem| Warranty period| Service content
---|---|---|---
Motor| Motor will not be able to use| 1 year| Free delivery of parts
Accelerator| Natural conditions (such as impact force cannot be used except damage )| 1 year| Free delivery of parts
Controller| Failure occurs under normal use| 1 year| Free delivery of parts
Charger| Failure occurs under normal use| 1 year| Free delivery of parts
Lithium Battery| Can’t charge discharge under normal use| 1 year| Free delivery of parts

Notes:
If the above issues occur during the protection period, please contact us and send us photos or videos of the defective parts. If we confirm that the fault is caused by the quality of the product itself we will send you the parts that are needed replaced for free.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals