Belling Cookcentre 100T Chimney Cooker Hood User Manual

: June 13, 2024
: belling

Table of Contents

Belling Cookcentre 100T Chimney Cooker Hood
Product Information
Product Usage Instructions
Warranty
CONTROLS
USE
CLEANING AND MAINTENANCE
TECHNICAL DATA
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Belling Cookcentre 100T Chimney Cooker Hood

Product Information

The COOKCENTRE CHIM 90T, COOKCENTRE CHIM 100T, and COOKCENTRE CHIM 110T are kitchen appliances manufactured by Glen Dimplex Home Appliances. They are chimney-style cooker hoods designed to remove smoke, odors, and grease from the air during cooking.
The appliances are available in various countries including Great Britain, Germany, Austria, France, Poland, Sweden, and the Republic of Ireland. Glen Dimplex Benelux B.V is the distributor in the Netherlands, while Glen Dimplex France is the distributor in Belgium. The appliances come with a 24-month guarantee against electrical and mechanical breakdown.

Product Usage Instructions

Read the user manual carefully before installing and using the appliance.
Keep the manual with the appliance at all times, even if you move or sell it.
Ensure that the wire connection is done by a specialized technician to prevent any safety hazards.
Maintain a minimum safety distance of 650 mm between the hob and the suction hood during installation. Some models may have different height requirements.
If the gas hob installation instructions specify a greater distance than indicated, follow the instructions provided.
Check that the mains voltage corresponds to the rating label affixed inside the hood.
Ensure that means for disconnection are incorporated in the fixed wiring according to wiring rules.
Connect the hood to the exhaust flue using a pipe with a minimum diameter of 120 mm. The flue route should be as short as possible.
Comply with all air venting regulations.
Do not connect the hood to exhaust ducts that carry combustion fumes from boilers, fireplaces, etc.
If the hood is used with non-electric appliances (e.g., gas), ensure sufficient room aeration to prevent exhaust backflow. The negative pressure in the room should not exceed 0.04 mbar.
Do not discharge the air into a flue used for exhausting fumes from appliances burning gas or other fuels.
If the supply cord is damaged, it must be replaced by the manufacturer or its service technician.
Connect the plug to a socket that complies with the electrical standards and regulations of your country.

Great Britain| Glen Dimplex Home Appliances, Stoney Lane, Prescot, Merseyside, L35 2XW|

General enquires: 0344 815 3746
Spares: 0344 815 3745
Warranty Registration: 0800 952 1068 www.belling.co.uk gdhainfo@gdha.com

---|---|---
Nederlands| Glen Dimplex Benelux B.V. Saturnus 88448 CC Heerenveen|

Tél. : +31 (0) 513 656520
Productregistratie / Registration de produit: https://belling.eu/klantenservice/product- registratie
Service aanvraag/Demande de service: www.stoves.eu
https://belling.eu/klantenservice/doe-een- serviceverzoek

Belgien België Belgique| Glen Dimplex|

Tel./ Tél. : +32 (0) 92100211
Product Registration: https://belling.eu/klantenservice/product- registratie
Service /Demand: www.stoves.eu https://belling.eu/klantenservice/doe-een- serviceverzoek

Deutschland Austria| Sagoma Münsterstraße 559065 Hamm|

Telefon: +49 2381 – 3074390
Fax: +49 2381 – 3074398 www.sagoma.de

France| Glen Dimplex France 14 aveune de L’Europe 77144 MONTEVRAIN| Email: direction@glendimplex.fr
Poland| Cooking Store ul. Wadowicka 8a 30-415 Kraków, Poland| Tel:+48 12 35 06 230 www.cookingstore.pl
Sweden| Lindström & Sondén AB Havsbadsvägen 126263 Ängelholm|

Tele: 010-1011656
Email: info@lsbolagen.se

Republic of Ireland| Dimpco, Airport Road, Cloghran, Co. Dublin| Service Telephone No.: (01) 8428222 Service and Spare Parts. www.dimpco.ie

Warranty

Your new appliance comes with our 24-month guarantee, protecting you against electrical and mechanical breakdown.
Register online or by phone.
For full terms & conditions of the manufacturer’s guarantee, please refer to the website above.
Our policy is one of the constant development and improvement, therefore we cannot guarantee the strict accuracy of all our illustrations and specifications.
Changes may have been made after publishing.

SAFETY INFORMATION

For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. Users must fully know the operation and safety features of the appliance

The wire connection has to be done by specialised technician.
The manufacturer shall not be held liable for any injury or damage caused by improper installation or use
The minimum safety distance between the hob and the suction hood is 650 mm (some models may be fitted at a lower height; please see the paragraph relating to working dimensions and installation).
If the instructions for installa- tion of the gas hob specify a distance greater than the one indicated, this must be taken into account.
Check that the mains voltage corresponds to the one indicated on the rating label affixed inside the hood.
Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
For Class I appliances, check that the domestic power supply is adequately earthed.
Connect the hood to the exhaust flue using a pipe with a minimum diameter of 120 mm. The route of the flue must be as short as possible.
All the air venting regulations must be complied with.
Do not connect the hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc.).
If the hood is used in con-junction with non electric appliances (e.g. gas), a sufficient degree of aeration must be guaranteed in the room to prevent any exhaust backflow. The negative pressure in the room must not exceed 0.04 mbar to prevent fumes being drawn back into the room by the hood.
The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.
If the supply cord is dam-aged, it must be replaced by the manufacturer or its service technician.
Connect the plug to a socket that complies with current regulations and is in an accessible position.
As regards the technical and safety measures to be taken for fume discharging, it is important that the regulations set by local authorities must be complied with.
CAUTION: remove the protective films before in- stalling the hood.
Only use screws and hardware of a sort suitable for the hood.
CAUTION: failure to install the screws or fixing devices as described in these instructions may mean there is a risk of electric shocks.
Do not look directly at the light through optical devices (binoculars, magnifying glasses…)
Do not flambé food under the hood: you might cause a fire.
This appliance may be used by children over the age of 8 years and by persons with limited psycho-physical and sensory abilities or with in-sufficient experience and knowledge, provided they are carefully supervised and instructed on how to use the appliance safely and on the dangers that it involves.
Cleaning and maintenance to be performed by the user must not be carried out by children, unless they are under supervision.
Supervise children, to make sure they do not play with the appliance.
The appliance must not be used by persons (including children) with limited psycho-physical or sensory capacities or with insufficient experience and knowledge, unless they are carefully supervised and instructed.
Accessible parts may become extremely hot during the use of cooking appliances.
Clean and/or replace the filters after the period of time indicated (danger of fire). See the paragraph on Maintenance and cleaning.
The room must be adequately ventilated when the hood is used simultaneously with appliances that use gas or other fuels (not applicable to appliances that only discharge air into the room).
The symbol on the product or on its packaging indicates that the product must not be treated as household waste. Disposed of at a specialist recycling centre for electrical and electronic components. By making sure that this product is correctly disposed, you will help prevent potential negative consequences for the environment and human health that might result from its improper disposal. For more detailed information on how to recycle this product, please contact your local council offices, local waste disposal service or the shop in which the product was purchased.

CONTROLS

BEL CHIM 603PYR
BEL CHIM 603T
BEL CHIM 803T

BUTTON| LED| FUNCTIONS
**| On| Starts the motor at speed one
–| Stops the motor
2| On| Starts the motor at speed two
3**| On| Starts the motor at speed three
| –| Turns the lighting system on and off

Warning: Button T1 will switch the motor to speed 1 before stopping it.

USE

The extractor hood has been designed exclusively for domestic use, to eliminate kitchen odours.
Never use the hood for purposes other than those for which it was designed.
Never leave naked flames under the hood when it is in operation.
Adjust the intensity of the flame so that it is directed onto the bottom of the cooking pan, making sure it does not engulf the sides.
Deep-fryers must be kept under constant supervision when in use: overheated oil may catch fire.

CLEANING AND MAINTENANCE

The activated charcoal filter cannot be washed or regenerated, and must be changed approximately every 4 months of operation, or less in the case of intensive use. (W)

The grease filters must be cleaned every 2 months of operation, or more frequently in the case of particularly intensive use. They can be washed in a dishwasher (Z).
Clean the hood using a damp cloth and neutral liquid detergent

LIGHTING

Replacement parts can be optained from our Customer Care (details at the beginning of the handbook)
Lamps in risk group 1 under IEC/EN62471 at a distance of 20cm and in exempt from risk group under IEC/ EN62471 at a distance of 30cm.

TECHNICAL DATA

Electricity Supply 230 – 240V ~50/60Hz
Classification Class I
Noise Level ( External Venting)
- Position 3: 65 dB
- Position 1: 46 dB
Motor Rating 160 W
- Grease Filters
- 90cm & 100cm: 3 of aluminium panels
- 110cm: 4 aluminium panels
Carbon Filter s 2 pcs (Available as Spares)
Extraction Rate
- Position 3: 580 m3/h
- Position 1: 250 m3/h