Honeywell TC30-50PEU Portable Evaporative Air Cooler User Manual
- June 13, 2024
- Honeywell
Table of Contents
Portable Evaporative Air Cooler
User Manual
Read and save these instructions before use
Model:TC30/50PE Series
TC30-50PEU Portable Evaporative Air Cooler
Customer Support:
USA: 1-800-474-2147
CANADA: 1-888-209-0999
^ Canada Customer Support service available for models sold in Canada
only.http://honeywellhomecomfort.com/
www.jmatek.com
Email: usinfo@jmatek.com
PARTS DESCRIPTION
- Control Panel
- Louvers
- Water Level Indicator
- Casters
- Handle & Remote Control Storage
- Remote Control| 7) Rear Grill & Mesh Filter
- Honeycomb Cooling Media
- Water Fill Door
- Power Cord & Plug
- Drain Plug
- Water Inlet Valve*
---|---
WARNING — READ AND SAVE THE AIR COOLER SAFETY & MAINTENANCE GUIDE AND
USER MANUAL BEFORE USING THIS PRODUCT. FAILURE TO FOLLOW THESE INSTRUCTIONS
MAY DAMAGE AND/ OR IMPAIR ITS OPERATION AND VOID THE WARRANTY. IN CASE THERE
IS ANY INCONSISTENCY OR CONFLICT BETWEEN THE ENGLISH VERSION AND ANY OTHER
LANGUAGE VERSION OF THE CONTENT OF THIS MATERIAL, THE ENGLISH VERSION SHALL
PREVAIL.
*Applicable for models with Water Inlet Valve only.
USE & OPERATION
CONTROL PANEL Icons on Display Screen
| **** | Power |
|---|---|
| Swing | |
| Cool | |
| Speed | |
| Low | |
| Medium | |
| High |
FUNCTION BUTTONS
POWER **Press the button to turn the unit on. The cooler will start
automatically at medium speed. After a few seconds the speed will switch to
low. To turn the unit off, press the button again.
SPEED
Press the SPEED button repeatedly to change the speed between | – || –
|||.
The indicator light will show the selected speed.
SWING
Press the SWING button until is illuminated on the display. The louvers will
begin to move left to right automatically. You can manually adjust the louvers
to change vertical air flow. COOL
You must add water before operating the unit in Cool mode. Press the button
until is illuminated on the display screen. The water pump will operate and
you will feel the cooler air after the Honeycomb Cooling Media is completely
wet.
REMOTE CONTROL ****POWER: ON / OFF
SPEED: Low / Medium / High
COOL: Evaporative Cooling ON / OFF
SWING:** Controls the motion of the louvers
- The remote control requires a CR2025 (1 x 3V) coin type or equivalent battery for replacement. Open the battery compartment at the back of the remote control and insert the battery inside. Care must be taken to insert the batteries according to the correct polarity (+ / –) markings shown inside the battery compartment.
- Always point the remote control signal transmitter towards the unit when operating. Make sure that the signal path is not obstructed.
- Remove the batteries if the unit is not going to be used for an extended period of time.
- Do not drop the remote control.
- Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
- Do not mix old and new batteries.
- Do not recharge the battery.
- Exhausted batteries are to be removed from the product and safely disposed of as per local regulations.
- Do not dispose of batteries in fire. Batteries may explode or leak.
- This product contains a lithium button/coin cell battery. If a new or used lithium button/ coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as 2 hours. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
- The batteries shall be disposed of properly, including keeping them away from children.
- Even used batteries may cause injury.
WARNING: Chemical Burn Hazard. Keep batteries away from children.
COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start
using the product. Please refer to the COOLER LOCATION section of the separate
Safety & Maintenance Guide.
FILLING WITH WATER
It is ideal to use the Continuous Water Supply Connection to run the unit for
long periods of time without refilling the tank. This also helps prevent pump
failure in case the cooler is running with inadequate water in the tank.
CAUTION: Unplug the unit from the electrical socket before emptying or
refilling the water tank.
Open the Water Fill Door located on the back of the unit.
Continuous Water Supply Connection:
For a continuous water supply, you will need a garden hose that is connected
to a mains water supply.
- Locate the male connector at one end of the garden hose. Insert the garden hose connector into the water inlet valve of the cooler. Screw and tighten the water inlet valve onto the threaded part of the garden hose connector, making sure the hose connector is secured to ensure there will be no leaks. If there is a leakage, the hose and the water inlet valve may not be connected properly. Try to disconnect, replace and tighten the water inlet valve again.
- When the connection is secured, turn ON the water supply and the water will flow into the water tank of the cooler.
- The cooler is now set so the water refills automatically.
- When the water tank is full of water, the water inlet valve will auto-matically stop the water supply from overflowing the water tank.
WARNING: The maximum water inlet pressure is 0.5 MPa.
The Water Level Indicator is located at the back of the unit. Refill the water
tank when water level is low. Do not fill water above the “Max.” water level
mark to avoid water droplets collecting on the louvers. Check the water level
in the tank before running the COOL function. Make sure there is water in the
tank by using the continuous water supply connection or by filling the tank up
to the maximum indicator level. Running the unit in COOL mode with inadequate
water may cause pump failure.
Note: The water capacity refers to the total volume of water that can be
contained within the air cooler water tank and water distribution system. The
water capacity in the tank at the “Max.” indicator level may be lower than the
actual water capacity of the air cooler.
WARNING: Do not fill water tank with dirty water or salt water. This can
damage the unit and Honeycomb media.
**LOW WATER ALARM*
The unit is equipped with a low water sensor. In Cooling Mode, when water in
the tank is below the minimum level, you will hear a beeping sound and the
indicator light will flash continuously. The unit will automatically pause
evaporative cooling.
Refill the water tank to deactivate the alarm in cooling mode. First switch
OFF the unit and unplug from the power outlet. Fill the water tank with water
above the minimum water level mark. Plug in and switch ON again.
To deactivate the alarm and continue using the unit as a fan (without
evaporative cooling), switch the unit OFF and then ON again. The Low Water
Alarm will not activate in Fan only mode. The Low Water Alarm will sound again
if the COOL function is activated while the water tank is still empty.
CLEANING & DRAINING THE WATER TANK
Below are instructions on how to clean and maintain your air cooler. If the
cooler will not be used for a long period of time, please refer to the STORAGE
& MAINTENANCE GUIDELINES located in the separate Safety & Maintenance Guide.
WARNING:**
Before cleaning the unit, power OFF the unit and disconnect from the
electrical socket.
- Move the unit to a location where the water can be drained. Remove the cap from the drain plug located at the bottom of the unit. Allow the tank to empty.
- Refill the water tank with clean water, up to the maximum level and drain it completely.
- Use a damp cloth to remove the dirt and dust from the surface of the unit. Never use corrosive elements or chemicals to clean this product.
- When the product is not in use, store the unit in a dry place out of direct sunlight.
CLEANING THE MESH FILTER AND HONEYCOMB COOLING MEDIA
WARNING:
Before cleaning the unit, switch the unit OFF and disconnect the power adapter
from the unit and electrical socket.
- The appliance is supplied with a Mesh Filter and Honeycomb Cooling Media.
- The Mesh Filter and Honeycomb Cooling Media are located inside the Rear Grill. See Figure 1 for instructions on how to remove them from the unit for cleaning and maintenance.
- Do not run the unit in COOL mode with stale water in the tank. You must empty the water tank and refill with fresh water, especially if the tank has not been cleaned in a long time.
- The cleaning frequency for the Honeycomb media depends on local air and water conditions. In areas where the mineral content of water is high, mineral deposits may build up on the Honeycomb Cooling Media and restrict air flow. Draining the water tank and refilling with fresh water at least once a week will help reduce mineral deposits. If mineral deposits remain on the Honeycomb Cooling Media, the media should be removed and washed under fresh water. The media should be cleaned every two months or sooner, depending on your needs.
- For best results allow the Honeycomb Cooling Media to dry after each use by turning off the cool function 15 minutes before turning the unit off.
Removing the Mesh Filter and Honeycomb Cooling Media:
- Carefully pull out the rear grill / mesh filter from the cooler.
- Rinse the rear grill / mesh filter with clean water and let it dry before re-installing to the unit.
- Carefully pull out the Honeycomb Media.
- Replace or clean media with water and a damp cloth as needed.
WARNING: DO NOT operate the Air Cooler when the Rear Grill is removed from the Air Cooler, or if there is a loose-fitting Rear Grill. Doing so can cause serious injury or dangerous electrical shock.
Made in China
© 2018 JMATEK Limited. All rights reserved.
The Honeywell Trademark is used under license
from Honeywell International Inc.
Honeywell International Inc. makes no representations or warranties with
respect to this product.
This product is manufactured by Airtek Int’l Corp. Ltd.
(subsidiary of JMATEK Ltd.).
JMATEK North America LLC
Mahwah, New Jersey 07495 USA
Email: usinfo@jmatek.com
Web: www.jmatek.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>