TROXEL 000399732025 Helmet Brimmer Instruction Manual
- June 12, 2024
- TROXEL
Table of Contents
TROXEL 000399732025 Helmet Brimmer
Product Information
The Helmet BrimmerTM is an accessory designed to be installed on specific Troxel helmet models. It enhances the helmet’s sun protection by providing a visor extension. Please note that the Helmet BrimmerTM cannot be used with the following helmets: Terrain, Sport, Legacy, non-low profile Spirit, and all helmet versions prior to 2014. It is also not suggested for use with the ES model helmets.
Product Usage Instructions
- Select the appropriate size of the Helmet BrimmerTM based on your Troxel helmet model and size.
- Refer to the Helmet BrimmerTM Sizing Chart to determine if you need size A or B.
- Insert the helmet visor into the front pocket of the Helmet BrimmerTM.
- Push down the front of the Helmet BrimmerTM from the top side until it touches the helmet visor.
- Push down the rear of the Helmet BrimmerTM until it reaches a distance of 1/4 – 1/2 from the center rear edge of the helmet.
- Insert each plastic clip between the outer shell and liner of the helmet.
- Recheck the helmet fit with the installed Helmet BrimmerTM. Ensure that the helmet is level on your head and check the fit and straps to make sure the buckle is locked securely.
For more information, please visit
TROXELHELMETS.COM.
INSERT-98
Helmet Brimmer™ Installation Instructions
- STEP 1: Select Helmet Brimmer™ Size
1. Locate the Troxel helmet model and size of the helmet you have on the chart above.
2. Refer to the size chart to determine if you need size A or B. Helmet Brimmer™ cannot be used with the following helmets: Terrain, Sport,
Legacy, non-low profile Spirit and all helmet versions prior to 2014. **Not
suggested for use with the ES model helmets
- STEP 2: Insert helmet visor into front. pocket of the Helmet Brimmer™.
- STEP 3: Push down the front of the Helmet Brimmer™ from the top side until the Helmet Brimmer™ touches the helmet visor.
- STEP 4: Push down the rear of the Helmet Brimmer™ until you get to 1/4″ – 1/2″ distance from the center rear edge of the helmet.
- STEP 5: Insert each plastic clip between the outer shell and liner of the helmet.
- STEP 6: Recheck helmet fit with the installed Helmet Brimmer™. With the helmet level on your head, check the fit and straps to make sure the buckle is locked securely.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>