robbe 50611 Modellsport Ruder Deflection Indicator Instruction Manual
- June 12, 2024
- robbe
Table of Contents
SHORT ASSEMBLY INSTRUCTIONS
„M“
NO. 50611
RUDDER DEFLECTION GAUGE
DESCRIPTION
Simple and useful tool for clean adjustment of rudder deflections on model aircraft. Secure hold on the wing or rudder by suction cups. Precise and fine resolution scale. Kit, can be assembled in just a few steps.
Scale: 0-40 mm
The scale for measuring the rudder deflections must first be glued together (wood glue):
Now glue the plastic holders for the steel wire bracket to the back (super glue). Afterwards the bracket can be clipped into the plastic holders:
The „suction cup“ is guided through the steel wire bracket and fixed with a lock washer. Make sure to use the smaller of the holes in the suction cup! If necessary, widen them slightly with a screwdriver:
The finished rudder gauge in use:
DISTRIBUTOR
Robbe Modellsport
Industriestraße 10
4565 Inzersdorf im Kremstal
Austria
Phone: +43(0)7582/81313-0
Mail: [email protected]
UID No.: ATU69266037
„robbe“ is a registered Trademark.
Errors, misprints and technical changes reserved.
Copyright 2023
Robbe Modellsport 2023
Copy and reprint only with our permission.
Service-Address
Contact your Dealer or:
Robbe Modellsport
Industriestraße 10
4565 Inzersdorf im Kremstal
[email protected]
+43(0)7582-81313-0
Made in China +14
Documents / Resources
|
robbe 50611 Modellsport Ruder Deflection
Indicator
[pdf] Instruction Manual
50611 Modellsport Ruder Deflection Indicator, 50611, Modellsport Ruder
Deflection Indicator, Ruder Deflection Indicator, Deflection Indicator,
Indicator
---|---