marta MT-EO4299A Mini Oven User Manual
- June 12, 2024
- MARTA
Table of Contents
marta MT-EO4299A Mini Oven
Product Information
- Product: Electric Oven
- Model: MT-EO4299A
- Manufacturer: COSMOS FAR VIEW INTERNATIONAL LIMITED
- Address: ROOM 701, 16 APT, LANE 165, RAINBOW NORTH STREET, NINGBO, CHINA.
- Website: http://multimarta.com/
Specifications:
- Power Supply: 230V ~ 50Hz
- Power Consumption: 2000W
- Timer Range: 30 minutes to 7.35 hours
- Dimensions: 533mm x 372mm x 357mm
Product Usage Instructions
- Before using the appliance, make sure to read the user manual carefully.
- Switch on all heating elements by selecting the desired heating mode using the heating mode adjustment knob (position 5).
- If the products are not ready yet, set the additional operating time by turning the timer knob.
- To achieve better cooking performance, it is recommended to pre-heat the oven for about 10-15 minutes.
- Do not use the appliance continuously for more than 4 hours without a break.
- After using the oven, let it cool down before cleaning or performing any maintenance.
- Clean the oven following the cleaning procedure mentioned in the user manual.
- Ensure that the oven is properly connected to a power supply before switching it on.
- Refer to the parts list in the user manual for information on the different components of the oven.
- Keep the appliance away from flammable materials and ensure proper ventilation during operation.
- If there are any issues or concerns, contact the manufacturer’s customer support at 8(812) 325-2334.
Parts list
- Housing
- Door with handle
- Temperature control knob
- Operation indicator light
- Heating mode selection knob
- Convection/rotisserie switch-on knob
- Timer setting knob
- Rotisserie and handle for removing
- Bake tray
- Skewer
- Handle for removing the bake tray/Wire rack
- Crumb tray
- Wire rack
Real set of the appliance could be different from listed in the User manual. Check once buy.
CAUTION
Read this manual carefully before using the appliance and save it for future reference. When using electrical appliances, basic precautions should always be followed, including the following:
- The appliance is designed for domestic cooking and heating only in accordance with these operating instructions.
- Before the first use, check the device specifications and the power supply in your network. Use the appliance only on the voltage specified on the identification plate.
- The device must always be connected to a grounded socket.
- It is not intended for industrial use.
- Use the device in a well-ventilated room with at least 15 cm. space on each side for normal air circulation and heat removal.
- Do not allow the operating device to come into contact with fusible or flammable materials, fabrics, curtains, etc.
- For indoor use only. Use only for domestic purposes according to the instruction manual. Do not use or store the unit in damp and moist areas where it may come in contact with water.
- Do not place or use the unit on or near other household appliances (a hot gas or electric burner, etc.)
- Do not use the appliance near explosives or flammable materials.
- Do not use with damaged cord, plug or other injuries. Do not move the device by holding the cord.
- Keep the power cord away from sharp edges and hot surfaces. Do not pull the cord. Always take the socket, not the wire. Do not reel the cord around the device housing.
- Never attempt to frame and repair the appliance by yourself. If you meet problems, please contact the nearest customer service center.
- Excessively large products, vacuum-packaged products, cardboard, paper, plastic wrapping/ware/baking molds must not be cooked in the appliance as this can cause a fire.
- Do not heat oil in the appliance. Using accessories or replacement parts that are not recommended or sold by the manufacturer may cause damage to the appliance.
- Place the appliance on a flat, stable, and heat-resistant surface that can support the weight of the appliance with food and cooking utensils.
- Incorrectly assembled devices may cause fire, electric shock or other injury.
- DANGER: Do not cover the device with anything while it is in operation! Do not place any objects on it!
- To avoid electric shock and fire, do not immerse in water or other liquids. If this occurs, immediately unplug it and contact the service center for inspection.
- Do not touch the appliance, the power cord, and the plug with wet hands!
- This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
- Keep out of the reach of children. Close supervision is necessary when this appliance is to be used by or near children.
- Do not switch on an empty device without food for more than 15 minutes.
- The maximum allowable continuous operating time is 4 hours.
- Do not allow products to come into contact with heating elements.
- Keep water away from the hot glass as it may crack. Do not physically expose the door or glass – do not place any objects or lean on it.
- Always unplug the appliance and let it cool down before cleaning and removing parts. Keep unplugged when not in use.
- WARNING: This device heats up during use. The temperature of the door or other surfaces may be exceeded when the appliance is in operation.
- Do not touch the hot surfaces or heating elements inside to avoid burns. Use special accessories, kitchen tackles, or mittens.
- WARNING: Failure to observe safety precautions may result in fire, electric shock, or burns. Damage to the appliance caused by improper use will exempt the seller from warranty service.
BEFORE THE FIRST USE
- Unpack the appliance and remove all packaging materials and labels. Store warning labels (if available) and the product serial number plate on the housing!
- Clean the device with a damp cloth, clean the accessories in soapy water rinse thoroughly, and dry.
- Make sure that there are no packaging materials or foreign objects (including products) inside.
- Switch on all heating elements by selecting heating mode , set the maximum temperature to 230°C, and timer for 15 minutes. Some smoke or odor may be produced at the first switch-on, this is normal and not a malfunction. At the end of this cleaning procedure, let the unit cool down, after which it will be ready for operation.
USING THE APPLIANCE
SWITCHING ON
- Make sure the device is switched off (timer adjustment knob is in the «OFF/0» position). Connect the device to the power supply.
- Install a bake tray and/or wire rack, place the food. If the food is cooked on the wire rack/skewer/rotisserie, place the bake tray on the bottom level to prevent oil/grease/juice droplets from getting onto the heated surfaces.
- Turn the temperature adjustment knob “3” to set the desired temperature from 100 to 250°C.
- Then turn the heating mode selection knob “5” to set desired heating mode.
- If you need to additionally enable the convection mode, or rotation of air fryer/skewer/rotisserie, or both modes together, turn the knob “6 ” to the desired position.
- To turn on the device, set the timer from 1 to 60 minutes by turning the timer setting knob “7”.
- The inner light and indicator light “4” will illuminate, the device starts working.
- After the set time has elapsed, an audible signal will sound, the inner light & indicator light will go out, and the device will stop working.
- If the products are not ready yet, set the additional operating time by turning the timer knob.
- In order to get better cooking performance, it is recommended to pre-heat the oven about 10-15 minutes. DO NOT USE THE APPLIANCE MORE THAN 4 HOURS WITHOUT A BREAK.
HEATING MODE SELECTION
To set the desired heating mode, turn the heating mode adjustment knob “5”
to one of the following positions:
- the upper heating elements operating mode.
- the upper & lower heating elements operating mode.
- the lower heating elements operating mode.
- all heating elements & operating modes are off.
SWITCHING ON CONVECTION MODE AND ROTATION OF THE AIR
FRYER/SKEWER/ROTISSERIE
To turn on the convection mode or the rotation of the skewer/rotisserie, or
both modes together, turn the knob “6” to one of the following positions:
- convection mode.
- convection mode & rotation of the air fryer/skewer/rotisserie.
- rotation of the air fryer/skewer/rotisserie.
- convection mode & rotation of the air fryer/skewer/rotisserie are off.
USING THE ROTISSERIE
- Loosen the clamps on the retainers.
- Attach one retainer to the rod of the rotisserie, insert the rod through the product you are going to cook, place the food in the center of the rotisserie, and attach the second retainer. Make sure that the clamps are twisted and the impaled product is firmly fixed on the rotisserie. Do not allow the product parts to come into contact with the heating elements!
- Set the rotisserie with the right end in the drive hole in the center of the right wall inside the chamber, and the end with the cap in the slot holder located on the left wall of the chamber.
- Set the desired temperature, then choose desired cooking modes by turning the knobs “5” & “6” and setting the timer.
- To avoid burns, use the supplied handle “8” and gloves (not included) to install and remove the skewer or the rotisserie.
- To remove the rotisserie, first lift the left side of the rod so that it comes out of the slot holder, then remove the right side.
USING THE SKEWER
- Loosen the clamps on the retainers.
- Thread the rod through the square holes in the skewer (parallel to the shapruram).
- Tighten the clamps.
- Skewer the product you are going to cook.
- Set the skewer with the right end in the drive hole in the center of the right wall inside the chamber, and the end with the cap in the slot holder located on the left wall of the chamber.
- Set the desired temperature, then choose desired cooking modes by turning the knobs “5” & “6” and setting the timer.
- To avoid burns, use the supplied handle “8” and gloves (not included) to install and remove the skewer or the rotisserie.
- To remove the skewer, first lift the left side of the rod so that it comes out of the slot holder, then remove the right side.
SWITCHING OFF
- The device will automatically turn off when the time set on the timer expires.
- The device can be switched off at any time by turning the heating mode adjustment, temperature adjustment, and timer knobs to the “OFF” position. An audible signal will sound, the light indicator will go out, and the device will stop working.
- WARNING: Always turn off the unit when cooking is finished.
- Disconnect the appliance from the power supply. Do not pull on the wire, only hold on to the plug. Always allow the appliance to cool down completely before you put it away.
CLEANING AND MAINTENANCE
- Before cleaning, always unplug the appliance.
- Use a wet cloth to clean the device. Do not immerse the appliance in water or other liquids.
- Clean accessories in soapy water and dry them.
- Do not use chemical and abrasive cleaners for cleaning. Recommended to clean the device right after operating.
SPECIFICATION
Power supply| Power, W| Capacity, L| Net weight/Gross weight, kg| Package size
(L х W х H), mm
---|---|---|---|---
230 V ~ 50 Hz| 2000| 30| 7,35/8,50| 533 х 372 х 357
Producer:
COSMOS FAR VIEW INTERNATIONAL LIMITED
Room 701, 16 apt, Lane 165, Rainbow North Street, Ningbo, China
Made in China.
WARRANTY
WARRANTY DOES NOT COVER SUPPLIES (filters, ceramic and non-stick coating,
rubber seals, etc.)
The production date is available in the serial number located on the
identification sticker on the gift box and/or on the sticker on the device.
The serial number consists of 13 characters, the 4th and 5th characters
indicate the month, and the 6th and 7th indicate the year of device
production. The producer may change the complete set, appearance, country of
manufacture, warranty, and technical characteristics of the model without
notice. Please check when purchasing the device. Current information about
service centers is available on the website http://multimarta.com/.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>