APRIA React Health Luna G3 Sleep Therapy Device User Guide

APRIA React Health Luna G3 Sleep Therapy Device

Get Started
Reference your Apria Sleep Therapy User Guide or go to Apria.com/Sleep for more details.

INSTALLATION INSTRUCTION

1. Place the device on a firm flat surface.

2. Connect the Power Cord: Insert the plug of the power adapter into the DC inlet on the back of the device. Connect the power cord to the power adapter. Plug the other end of the power cord into the power outlet.
   NOTE: If you have a BPAP device see User Guide page 4 to connect the Power Cord Locker.

3. Connect the end of the tubing to the air outlet of the device.
   If using heated tubing, connect the heated tubing joint to the air outlet of the device, and then insert the power plug into the heated tubing port on the back of the device.
   Connect the other end of the tubing to the mask according to the user manual for the mask.

4. Press down the water chamber, and then remove it. Open the water chamber cap and fill the water chamber with approximately 360 ml of water.

5. Close the cap after the water is filled and return it to the device.

6. If you received an SD card, insert it into the SD card slot. Note: Newer devices do not need an SD card.

7. Connect the device to a power outlet, press the Start/Stop button and the device will start delivering air.

8. Fit your mask. If your doctor prescribed a specific mask and size, follow the fitting instructions provided by the manufacturer. If you received a mask with multiple cushions, follow these instructions:
   There is a mask cushion currently attached to the frame of your mask. This size fits most patients. Once you begin therapy, if your mask is leaking or feels uncomfortable, try removing the existing cushion and replacing it with a different size cushion. If you are between sizes, it is best to use the larger cushion. Use the Fitting Template (for nasal mask and full face mask) and/or the manufacturer’s instructions included with your mask for help.

9. Put on your mask.

10. Attach the tubing to the PAP machine.

11. Attach the tubing to your mask.
    (If using prescribed oxygen, consult page 11 in your Apria Sleep Therapy User Guide.)

12. Lie down and take four deep breaths.
    The machine should start automatically. If you do not hear the machine start, press the Start Therapy/Standby button. Relax and begin to take slow breaths through your nose.

13. Check for air leaks.
    Small leaks are acceptable. If large leaks occur, consult your Apria Sleep Therapy User Guide.

14. Your setup is complete. You are now ready to begin your PAP therapy!

15. Make sure to follow the cleaning and maintenance instructions provided and review the recommended supply replacement schedule.

If you have any questions or need help setting up your device and getting started, please call us or visit Apria.com/Sleep
877.265.2426
Monday – Friday: 8 a.m. – 10 p.m. ET
Saturday: 11 a.m. – 7:30 p.m. ET

References

• Apria Sleep Care

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>