VAXEE ZYGEN NP-01S Wireless Mouse User Guide
- June 12, 2024
- VAXEE
Table of Contents
VAXEE ZYGEN NP-01S Wireless Mouse
Contents of Package
- Mouse
- Wireless Dongle (USB)
- Wireless Dongle Adapter
- Charging and Data Cable
SETUP
Wired Mode
Connect the mouse to any USB port on your PC
Wireless Mode
Plug the wireless USB dongle into any USB port on your PC
Mouse Features
- Left Button
- Right Button
- Middle Button
- Back Button
- Forward Button
- Switch Button
- Report Rate Button
- Click Latency Button
- Power Switch
Specifications
- DPI Settings: 400 / 800/1600 / 3200 dpi
- Adjustable USB Report Rate: 125/500 /1000 Hz
- Adjustable Click Latency: 2/3 / 4 / 8 ms
- Adjustable Competitive Mode: On / Off
- Adjustable Motion Sync: On / Off
- Battery Life: Consistent motion at 1000Hz – Up to 100hrs in Standard Mode and 55hrs in High Competitive Mode
- Charging Speed: From 0%-100% in roughly Ihr 50mins
- Weight: 69g
- Sensor: PAW3395
- Connector: USB
- Buttons: 9 buttons
- Cable Length: 2 meters (6.6 feet)
DPI
- 400 dpi
- 800 dpi
- 600 dpi
- 3200 dpi
Recommended Usage Environment
For optimal wireless performance, use a mouse within 20cm of the Wireless Dongle and further than 2m from sources of 2.4GHz interference (such as Wi-Fi routers)
Charging and Power LED Lights
LED Lights during Charging
Hold the Right Button (2) + Middle Button (3) to display the current charge
level of the mouse.
- Connect the USB cable to use it in wired mode
- Charging: Both lights blink in a cycle
- Fully Charged:
- Both lights stay on continuously
Lift-off distance Adjustment
Hold the Report rate switch button (7) while the power is off, then turn on the power:
Motion Sync Adjustment
Competitive Mode Adjustment
Displaying Mouse Status
B Dongle Function
- NP-O1S Wireless provides an A/ B dongle switch function.
- If you require an additional dongle, please visit the VAXEE website to make your purchase.
- For dongle pairing and switching.
- please scan the OR code below for the ‘VAXEE Dongle User Manual”
Regulatory
FCC Approval
This device had been tested in accordance with the procedures and in
compliance with Part 15 subpart b of 083 4 8 FCC Part 158 Reculaton and C
SPR/2 Class E
FCC 15.21
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment This
device complies with part of the FCC Rules Operation is subject to the
following two cond tons This device may not cause harmful interference and
this device must accept any interference received, including interference that
may cause undesired operation This equipment has been tested and found to
comply with the limits for a Class B daal device, pursuant to part 15 of the
FCC Ruler.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receive
RE Exposure Warning : This device contains transmitters and receiver sot by the Federal Communications Commission FOC) of the United States, industry Canada c) of Canad.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>