MAYTAG W11423741A 27 Inch Fingerprint Resistant Stainless Steel Electric Built In Single Oven Instruction Manual

MAYTAG W11423741A 27 Inch Fingerprint Resistant Stainless Steel Electric

Built In Single Oven

Product Information

The product is an oven that requires proper installation to avoid damage to the oven or floor. It is important to follow the instructions provided to ensure safe and correct installation.

Installation Precautions

• Do not remove the side door spacers until the oven is ready to install. Removing the door spacers could cause the door to shift, damaging the door latch.
• Do not place the oven directly on the floor as it can cause damage. Use a bottom base pad for installation.
• Avoid lifting or moving the oven by the door handle(s) or control panel.

Removing and Replacing the Oven Door:

Prior to installing the oven, it is necessary to remove the oven door. Follow these steps:

1. Fully open the oven door.
2. Rotate the door hinges from the locked to unlocked position.
3. Gently start to close the door until it stops at a partially closed position.
4. Using two hands, grasp the edges of the oven door and close it slightly past the stop position to take the weight off of the door hinges.
5. Pull the oven door towards you and gently shift it from side to side as you pull to remove it.

To replace the oven door, follow these steps:

1. Using two hands, grasp the edges of the oven door.
2. Insert the hinges at the same time and push the oven door into the oven cavity slot to replace it.
3. Gently shift the door from side to side as you push to ensure proper placement.
4. Make sure the door hinge notch is engaged on the bottom of the oven cavity slot.
5. Do not close the door at this step to avoid damage to the door hinges.

INSTALLERS

TO AVOID DAMAGE TO OVEN OR FLOOR

• Do not remove the side door spacers until the oven is ready to install.
• Removing the door spacers could allow the door to shift, damaging the door latch.
• Door spacers are provided on some models.
• Do not remove oven from bottom base pad until oven is ready to install.
• Setting oven directly on the floor can cause damage to the floor.
• Do not lift or move oven by door handle(s) or control panel.
• Prior to installing the oven, you will need to remove the oven door(s). Prepare a surface where you will place the door(s).
• This surface should be flat and covered with a soft blanket, or use the corner post from the packaging material.

To remove the oven door

• Fully open the oven door.
• Rotate door hinges from locked to unlocked position.
  • NOTE: This instruction covers different models and your hinge may vary slightly from the one illustrated.
• Repeat previous step for door hinge on opposite side.
• Gently start to close the door. The door will stop at a partially closed position.
• Using two hands, grasp the edges of the oven door. Close the oven door slighly past the stop position to take the weight off of the door hinges and then pull the oven door up.
• Pull the oven door toward you and then remove. You may need to gently shift door from side to side as you pull.

To replace the oven door

• Using two hands, grasp the edges of the oven door. Insert the hinges at the same time and push the oven door into the oven cavity slot to replace. You may need to gently shift door from side to side as you push.
• Make sure the door hinge notch is engaged on the bottom of the oven cavity slot.
  • IMPORTANT: Do not close door at this step or damage may occur to the door hinges.
• Fully open the oven door.
• Move door hinges from unlocked to locked position.
  • NOTE: This instruction covers different models and your hinge may vary slightly from the one illustrated.
• After the door hinges have been locked, gently swing the door upward to close. The door should not be forced closed. Check that the hinges are locked if there is any resistance while closing the door.

Follow installation instructions found in bag containing literature.

©2020 All rights reserved. Used under license in Canada.

Printed in U.S.A.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>