Rain-Flo IRRIGATION 2370 Flat Bed Plastic Mulch Layer Instruction Manual
- June 4, 2024
- Rain-Flo IRRIGATION
Table of Contents
Rain-Flo IRRIGATION 2370 Flat Bed Plastic Mulch Layer
Assembly Instructions
Unpackage & Count Parts/Assemblies
Standard Parts Shipped with Equipment:
**Press Wheels
**
See Operating Manuel for adjustments.
**Rear Cover Disks
**
See Operating Manuel for adjustments.
Tractor Hook-Up
The Model 2370 has Category I and II lift pins(A) on a 3-point hitch. Hook
up a 3-point top link to the top of the A-frame(B) and adjust the top link to
the level machine.
INSTALLATION
Installing Drip Tape Roll
See Operating Manuel for Adjustment ****
Drip Tape: Remove the plate with a locking clamp(A). Slide drip rolls onto the
rod, press plate(A) tight against the roll, and tighten the tee handle on the
clamp. Feed drip tape through swing arm guide and stationary guide(B) (See
sketch) then into the down pipe(C).
Note; Turn drip emitters up toward plastic for less clogging, and make
sure drip roll is compressed firmly between plates, for a positive braking
effect.
Installing Plastic Rolls
See Operating Manuel For Adjustment
Adjust roll holders(A) to your plastic roll widths (see Operating Manuel) and lay plastic rolls on top of rollers(B). Pull the plastic end down between the two rollers and underneath the bottom roller(C). Secure plastic and drip tape at end of the row. Only feed from one plastic roll at a time.
2021 Edition
Documents / Resources
|
Rain-Flo IRRIGATION 2370 Flat Bed Plastic Mulch
Layer
[pdf] Instruction Manual
2370 Flat Bed Plastic Mulch Layer, 2370, Flat Bed Plastic Mulch Layer
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>