JAXSUNNY HG91S0320 Solar-Powered Heated Poolside Beach Shower User Manual

HG91S0320 Solar-Powered Heated Poolside Beach Showe

User Manual

Solar-Powered Heated Poolside Beach Shower

Dear Customer,
Thank you for your purchase.
JAXSUNNY is committed to providing affordable high-quality furniture worldwide.
Each piece is made with the respect for human and the environment.
Thousands of families use JAXSUNNY products as a home fashion.
When you receive the product, please make sure that all the parts are intact.
Then please browse the entire installation manual before assembly.
If problems occur unsatisfactorily as follows:

1. The outer box is damaged.
2. The product is damaged / bent / cracked while you open the box.
3. The parts / accessories / assembly tools are missing.
4. The product is hard to assemble.
5. The instructions are not clear and can not be referred to.
6. The product has functional problems.
7. Other aspects that you are not satisfied with.

Please do not hesitate to contact us for help (Be sure to mark the SKU NUMBER, e.g., HG91S0320, and the TRACKING NUMBER).
Our JAXSUNNY team with factory direct after-sales service will reply within 24 hours and will do our best to resolve the problem for you. Our services are available at any time.

Sincerely,
JAXSUNNY Team

ASSEMBLY INSTRUCTIONS

1. Choose a location which will receive as much as possible sunlight for your solar shower.
2. Mount the lower stand with shower base (B) to concrete slab or wood base with four bolts, washers and nuts (K). We recommend to use wrench.
3. Attach shower head (0) with gasket (G) to the extension pipe (E). Attach the extension pipe (E) with gasket (F) into the thread of the upper stand (A). Adjust this pans only with your hands. Do not use a wrench.
4. Put the 0-ring (C) onto the lower stand (B).
5. Lift the upper stand (A) onto the lower stand (B). Connect the hoses.
6. Turn the locking ring clockwise to connect the two stands (A + B). Handle and shower head (D) need to face the same

INITIAL SET UP OF THE SOLAR SHOWER

1. Open the handle and turn it to position “hot”. This ensures that no air pockets are trapped in the hoses while filling with water.
2. Attach your garden hose to the hose connector (1). Turn on the water to fill the solar shower. It will take some minutes to fill up the solar shower.
3. When the water flows out of the shower head (D) turn the handle off. Now the solar shower begins to heat the water.
4. Depending on available sunlight and outside temperature, the solar shower will take about two hours to fully heat the water.
5. Water temperature in the solar shower can reach up to 60 °C during strong sunshine.

WARNING: To avoid scald, pay attention to turn the handle to “cold” water position before using the solar shower. Then adjust the desired temperature.

WINTERIZATION

1. Turn off and disconnect the garden hose.
2. Open the handle and turn it to position “hot” to allow the water to drain out of the hoses and solar shower (This takes 8- 10 minutes). Do not touch or turn the handle while draining, otherwise the water will stop draining out.
3. Turn the locking ring counter-clockwise to unthread the upper stand (A) from the lower stand (B). After this, please disconnect the hose connection. Now the water can run out of the solar shower.
4. Dissemble the lower stand (B) and pour the remaining water out of the solar shower.
5. Clean and dry all solar shower parts.
6. Store all solar shower parts indoors and in a dry place during winter season to prevent frostbite.

JAXSUNNY,
for Home and Fashion!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>