MAREKO Deep Platen Assembly Instruction Manual
- June 12, 2024
- MAREKO
Table of Contents
MAREKO Deep Platen Assembly
Product Information
The MAREKO Deep Platen Assembly is a component designed for use with a machine. It consists of a Wear Plate and short 1/4 HexBolts.
Wear Plate
The Wear Plate is a durable plate that is used to protect the Flat Platen
of the machine. It is installed using the short 1/4 Hex Bolts.
Short 1/4 Hex Bolts
The short 1/4 Hex Bolts are used to secure the Wear Plate to the Flat
Platen of the machine. It is important to align the Wear Plate with the belt
on the machine before tightening the bolts. Please note that overtightening
the bolts may strip the threads in the wear plate, so it is important to
tighten them securely but not excessively.
Product Usage Instructions
- Locate the Wear Plate and the short 1/4 Hex Bolts.
- Position the Wear Plate on the Flat Platen of the machine, aligning it with the belt.
- Insert the short 1/4 Hex Bolts through the designated holes on the Wear Plate and into the Flat Platen.
- Tighten the bolts securely using an appropriate tool, ensuring that the Wear Plate is firmly attached to the Flat Platen.
- Be careful not to over-tighten the bolts, as this can strip the threads in the wear plate. Tighten them securely but not excessively.
Following these instructions will properly install the MAREKO Deep Platen Assembly onto your machine, providing protection to the Flat Platen during usage.
MAREKO DEEP PLATEN ASSEMBLY
-
Place one Teflon washer between Arm and D-Plate where the D-Plate will rotate (red arrow). Install the
-
Platen D-Plate with ½-13 X 2-1/2 Carriage Bolt, Flat Washer, and Nylock Nut on the Short Arm.
-
Insert the ½”-13 X 2-1/2” Carriage Bolt into the slot and secure with ½-13 Internal Threaded Adjustable Handle.
-
Install the 2” Idler Wheel into the top (thinner section) of the Platen D-Plate using ½”-13 X 3” Hex Bolt, Spacer, and Nylock Nut.
-
Install the 4” Contact Wheel into the bottom (wider section) of the Platen D-Plate using ½”-13 X 3” Hex Bolt, Spacer, and Nylock Nut.
BE CAREFUL NOT TO OVERTIGHTEN BEARINGS. THE WHEEL SHOULD SPIN FREELY BUT THERE SHALL NOT BE EXTRA SPACE BETWEEN THE BEARINGS AND NUT OR BOLT HEAD. -
Install the Platen onto the Platen D-Plate using ¼”-20 Threaded knobs and ¼”-20 X 1” Carriage Bolts.
-
Install the Wear Plate to the Flat Platen using short 1/4” Hex Bolts. Align with belt on machine and tighten in place. Overtightening may strip the threads in the wear plate.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>