LTS DHD50 Turret Camera Installation Guide
- June 4, 2024
- LTS
Table of Contents
Turret Camera
Quick Installation Guide
Installation Notes Below
-
Before installation, loosen one Pan locking screw.
During installation, align the marks, and organize the cable as shown below.
Note: Keep connecting ports of the cable away from the locking screw area. -
Rotate the camera horizontally from 0° to 30° as shown below until it is adjusted to the best viewing angle, then tighten the locking screw.
-
Loosen the Tilt locking screw, and rotate the camera vertically from -75° to 75° as shown below until it is adjusted to the best viewing angle, then tighten the locking screw.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with a minimum distance between 20cm the radiator and your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>