IKEA RODRET Wireless Dimmer or Power Switch Instructions
- June 12, 2024
- Ikea
Table of Contents
IKEA RODRET Wireless Dimmer or Power Switch
RODRET wireless dimmer/power switch works with smart lights and plugs from IKEA. It can be used with DIRIGERA hub to control smart products via the IKEA Home smart app.
IKEA Home smart app
For Apple devices, download the app using the App Store. For Android devices, download the app using Google Play store.
Note: If you have a TRÅDFRI gateway please use IKEA Home smart 1 app.
Getting started with DIRIGERA hub
Download the IKEA Home smart app and follow the instructions on screen to add the dimmer/switch to your IKEA Home smart system.
Getting started without DIRIGERA hub
- Make sure the smart product you want to connect is installed and powered on.
- Hold your dimmer/switch close to the smart product (less than 5 cm away).
- Press and hold the pairing button for at least 10 seconds. A red LED will show on the dimmer/switch.
The smart product will pulse with a white LED once connected.
Good to know
Without DIRIGERA, you can connect a maximum of 10 smart products to one dimmer/switch. Remember to add one product at a time. If your products are close together, disconnect the ones you have already connected while adding the next product.
Get to know your product
Pairing button
Press to turn on, or long-press to increase brightness
Press to turn off, or long-press to decrease brightness
Changing the battery
A red LED light will blink when you press any button the dimmer/switch to show that a new battery is needed. Open the battery lid and replace with a new AAA/HR03 battery. We recommend using a LADDA rechargeable battery. Please note it is sold separately
Factory reset
To reset and remove all connected products, quick-press the pairing button 4 times (within 5 seconds). Follow steps 1-3 to reconnect your smart products.
Care instructions
To clean the product, wipe it with a soft cloth moistened with a little mild detergent. Use another soft, dry cloth to wipe dry. Never use abrasive cleaners or chemical solvents as this can damage the product.
IMPORTANT!
- The wireless dimmer is for indoor use only and can be used in temperatures ranging from 0º C to 40 ºC (32ºF to 104ºF).
- Do not leave the wireless dimmer in direct sunlight or near any heat source, as it may overheat.
- Different building materials and placement of the units can affect the wireless connectivity range.
WARNING!
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Technical data
Model: RODRET wireless dimmer
Type: E2201
Input: 1.2 V, 1x AAA/HR03 LADDA battery
Range: 10 m in open air.
For indoor use only
Operating frequency: 2405-2480 MHz
Output power: 3 dBm (EIRP)
IP-class: IP44
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN
FCC Statement
This device complies with Part 15 of the FCC Rules.
This device contains license-exempt transmitter(s)/ receiver(s) that comply
with Innovation Science and Economic Development Canada’s license-exempt RSS
standard(s).
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation of the device.
WARNING:
Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF EXPOSURE INFORMATION
This product is approved as a portable handheld device (not body worn)
This product includes a static magnet, generating a magnetic field that might interfere with the normal operation of pacemakers, defibrillators, or other medical devices.
Maintain a safe distance of separation between your medical device and this device. Stop using this device and consult your physician or medical device manufacturer if you believe that it is interfering with your medical device.
License rights and limitations
NO RIGHTS OR LICENSES, EXPRESS NO RIGHTS OR LICENSES, EXPRESS OR IMPLIED, ARE GRANTED TO USE THIRD-PARTY DEVICES IN COMBINATION WITH THESE PRODUCTS IN A WIRELESS MESH NETWORK, OR TO USE THIRD-PARTY SERVICES TO ACCESS, MONITOR OR CONTROL THESE PRODUCTS IN A WIRELESS MESH NEWORK VIA THE INTERNET OR ANOTHER EXTERNAL WIDE AREA NETWORK.
For use pursuant to U.S. Patent Nos.:
US 6,914,893
US 7,697,492
US 8,964,708
The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.
© Inter IKEA Systems B.V.
2022 AA-2389077-1