Yale YDM3109A Smart Door Lock User Manual
- June 12, 2024
- Yale
Table of Contents
Yale YDM3109A Smart Door Lock
Installation view
Left-handed door
Make sure to check door side before you stall. how to set : It automatically
sets when putting batteries. (See “2 Determine door type”)
The door should be in open position.
Right-handed door
DIMENSION
This template is based on 50mm thick door.
Caution
A and # shaded parts indicate the hole for mortise installation. If necessary,
door modification is required accordingly.
Package check
How to change lever direction!
Make sure to grab the lever for safety reasons when you change the direction
.
Determine door type
Left-handed door
Right-handed door
This product automatically detects the right and left side of door. (field reversible) (how to set: It automatically sets when putting batteries. The door should be in open position.) * Lever direction adjustment: see left detail.
Hole cutting
Left-handed door
How to adjust the door thickness
To install and use the product properly, proper use of hub handle & hub shaft according to the door thickness should be used
-
[ 70mm ~ 85mm ] ~
Add hub handle on the front handle. -
[85mm -over 90mm] Please use hub handle to a mortise and 1 hub shaft to a front handle should be used.
Caution
- Shown above is a diagram of the Cylinder key shaft and Mortise shaft in position within a particular door thickness.
- The minimum gap between the Cylinder key shaft and Mortise shaft should be 2mm or larger.
- The minimum depth of insertion for the Cylinder key shaft and Mortise shaft into the mortice lock should be 5mm or larger for each side.
- After cutting the Cylinder key shaft and Mortise shaft, check the lock function when the lock is installed in the door.
- If the shafts are cut too short or too long it may affect the deadbolt activation or cause other issues.
Installation
Mortise installation
Make sure the panic function screws(2ea) on the mortise are fixed from the
inside of door before mortise installation.
Front body installation
According to the door thickness, cut the cylinder and knob shaft.
Cable installation
Back body installation
Striker installation
After installation
Caution
Make sure to insert batteries when the door is in an open position (Make sure
that automatic right and left side door detection sets when the door is open
position.)
Checkpoints for Installer
-
The default Security Code is 1234567890 Test the Security Code works by pressing * 1234567890
-
After key (Fingerprint, card, i-button) registration, check the lock open.
-
Check the Automatic Locking works properly.
The door should automatically lock in 5 seconds after closing. -
Explain the Safe handle and how to set.
Checkpoints for the Owner
- Re-register your own Security Code.
- Read the User Manual before further use.
- Register your own keys.
- Understand the Emergency Power Supply feature.
- Understand the Forced Lock Modes.