TRUPER 13985 PROCO-20X Circuit Tester Instruction Manual

: June 12, 2024
: TRUPER

Table of Contents

TRUPER 13985 PROCO-20X Circuit Tester
GENERAL INSTRUCTIONS
MAINTENANCE
Warranty
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TRUPER 13985 PROCO-20X Circuit Tester

GENERAL INSTRUCTIONS

Verify that the tester lamp is holding the alligator clip securely on the negative (-) terminal of the vehicle and touching the positive () terminal of the battery with the test probe. If the test light comes on, the lamp is working. If not, replace the lamp.
Turn on the component to be checked. (The ignition may need to be in the on or accessory position).
Connect the alligator to a suitable ground (usually the vehicle frame or the point where the negative batterycable terminates).
Perform the test by touching the component with the probe or by piercing the component’s wiring insulation
If the tester light does not illuminate, then there is a fault in the circuit or no power is reaching the circuit.
Repair any damage to the wiring insulation caused by drilling, using electrical tape or silicone

MAINTENANCE

Dust with a damp cloth before use.

The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or by persons without experience or knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their- safety.

CAUTION: Children should be supervised to ensure that they do not play with the appliance.
Close supervision is necessary when handicapped persons or children use or are near any electrical appliance.

TO CHANGE THE LAMP: Unscrew the retainer from the end of the clear plastic handle. Remove the contact spring that iS connected to the defective lamp. Remove the defective lamp from the contact spring. Replace the lamp by sliding the spring over the lamp glass and turning it slightly. Use a G.E. No. 1889 lamp or equivalent. Install the lamp and spring in the clear plastic handle so that the bottom of the lamp faces the probe. Screw the retainer back into the plastic handle.

ELECTRIC DIAGRAM
6 V c.c. – 12 V c.c.

ATTENTION: READ THESE OPERATING INSTRUCTIONS AND FOLLOW ALL SAFETY ANDOPERATING INSTRUCTIONS BEFORE USE.

Warranty

Warranty. Duration: 1 year. Coverage: parts, components and workmanship against manufacturing or operating defects, except if used under conditions other than normal; when it was not operated in accordance with the instructive; was altered or repaired by personnel not authorized by Truper®. To make the warranty valid, present the product, stamped policy or invoice or receipt or voucher, in the establishment where you bought it or in Corregidora 22, Centro, Cuauhtémoc, CDMX, 06060, where you can also purchase parts, components, consumables and accessories. It includes the costs of transportation of the product that derive from the fulfillment of its service network. Phone number 800-018-7873. Made in China. Imported by Truer, S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec. Edo. de Méx. C.P. 54257, Phone number 761 782 9100.