Dale Tiffany TC20286 Dragonfly 1-Light Antique Bronze Wall Sconce Instruction Manual

Dale Tiffany TC20286 Dragonfly 1-Light Antique Bronze Wall Sconce

ASSEMBLY INSTRUCTIONS

Import Safety Instructions

• Power at the Fuse Box should be disconnected with this fixture.
• The Fixture ground wire (bare or green installed wire is NOT connected to current carrying supply wires).
• The Insulation on any of the wires must not be damaged during installation.
• No rough or sharp edges are in contact with any of the wires.
• Fixture wires are connected to the proper house supply wires. If you have any doubt contact a licensed electrician.
• Do not use light bulb (s) with wattage greater than those specified for this fixture. Power is off when installing light bulb (s) into the fixture.
• Insure the outlet box is well mounted to the building structure and will be able to support the weight of the fixture.

Read directions and follow steps 1~5

1. Carefully unpack and layout the parts as shown in illustration and read all instructions before starting.

2. Follow numbered steps on diagram. Screw Crossbar (3) to Wall Outlet Box (4) with appropriate Screws (5) (Screws not provided).

3. Connect Supply Wire with Fixture Wire using Wire Nut Connections (6).
   Please see connection procedures below:
   (I) Place the positive smooth wire from fixture evenly against with Black supply wire (7) from the outlet box (4).
   (II)Fix the wire nut connector (6) over the ends of two wires and screw the connector clockwise until you feel a firmness.
   (III) Try gently to pull the connector off the wires. If you can pull the connector off, carefully re-do the  step above and check again for a firm connection.
   (IV) Connect the negative ribbed wire (-) from the fixture to the white supply wire (8) from the outlet box (4) in the same manner.
   (V) Separately wrap the wire connections using electrical tape one inch before and include the connector.
   (VI) If your outlet box is provided with a grounding wire (9 – green or bare copper only ), attach this wire and the bare copper wire from the fixture to the green ground screw by wrapping both wires under the head of the screw and tightening screw. If outlet box is not provided with grounding wire, attach only the bare copper wire from the fixture to the green grounding screw. Tuck all wires into Wall Outlet Box.

4. Mount Flush Mount Canopy (10), to Crossbar (3) and secure using Decorative Knobs (11).

5. Follow Diagram on back side to attach for fixture assembly.

WARNING: TO AVOID THE RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

• Please contact electrician if necessary to install fixture.
• Shade and bulb assembly:
• Put the glass shade into the socket, and tighten the shade with ring, then install the bulb (not included).
  

Recommended maximum (1) 60 Watt Type A Bulbs (Bulbs not included)

FOR RETURN SHIPPING PURPOSES: PLEASE RETAIN ORIGNAL PACKAGING TO MINIMIZE DAMAGE.

CUSTOMER SUPPORT

LAYOUT ALL COMPONENTS AND REVIEW PARTS BEFORE ASSEMBLY
FOR ANY MISSING PARTS OR FOR ASSEMBLY INFO CALL: 1-800-382-3253
Made in China. / Hecho en

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>