EPOI ECBM-15W Wireless Charging Alarm User Manual

June 12, 2024
EPOI

EPOI ECBM-15W Wireless Charging Alarm

Product Information

Thank you for choosing our product, the ECBM-15W Wireless Charging Alarm. This device is a smart phone wireless charger that supports 15W power output and features 3 coils for enhanced charging efficiency. Please read the user manual carefully before using the product and keep it for future reference.

Specification

  • *  **Type-C Input:** 12V/2A
    • Wireless Output (Standard Model): 5W for all Qi standard wireless RX
    • Wireless Output (Fast Model): 7.5W for iPhone
    • Wireless Output (Fast Model): 10W for Samsung
    • Wireless Output (Fast Model): 15W for Qi EPP certificate Mobiles
    • 3 Coils: 1 Coil* 3
    • Charging Distance: 8mm
    • Frequency: 115KHZ – 205KHZ
    • Standard: Qi1.3.2
    • Conversion Rate for Wireless Charging: up to 80%
    • LED Panel: for status indicator
    • Product Size: LWH=1256010mm

Product Outline and Power Supply

EPOI-ECBM-15W-Wireless-Charging-Alarm-fig-1

To use the ECBM-15W Wireless Charging Alarm, please follow the instructions below:

  1. Connect the charger to a power source using the provided Type-C input cable.

  2. Place your Qi-compatible smart phone on the charger’s charging surface.

  3. Ensure that the phone is properly aligned with the coils on the charger for optimal charging efficiency.

  4. The LED panel on the charger will indicate the charging
    status:

    • Solid blue light: Charging in progress
    • Solid green light: Charging complete
    • Blinking blue light: Charging error or incompatible device
  5. When the phone is fully charged, remove it from the charger.

Note: For fast charging, make sure to use compatible devices that support the corresponding fast charging standards mentioned in the specifications.

Notes

  1. Do not squeeze or collied.
  2. Do not disassemble or throw into fire or water, to avoid causing a short circuit leakage.
  3. Do not use wireless charger in severely hot, humid or corrosive environments, to avoid circuit damage and occur leakage phenomenon.
  4. Do not place too close with magnetic stripe or chip card (ID card, bank card, etc.) to avoid magnetic failure.
  5. Please keep the distance at least 20cm between implantable medical devices (pacemakers, implantable cochlear, etc.) and the wireless charger, to avoid potential interference with the medical device.
  6. To take care of the children, to ensure that they won’t play the wireless charger as a toy, to avoid unnecessary accidents.
  7. Please keep the charger away from water or other.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference,
  2. This device must accept any interference received, including interference that may cause undesired operation.
    Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equip ment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.

FCC ID: 2BBPJ-ECBM-15W

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals