Amaztec Z12 Trio Magnetic Wireless Charger User Manual
- June 4, 2024
- Amaztec
Table of Contents
**Amaztec ** Magnetic Wireless Charger
Model: Z12 Trio
User Manual
Device Layout
Product Parameter
Product name: Magnetic Wireless Charger
Model: Z12 Trio
Material quality: ABS + Silicone
Dimensions: 24774.57.5MM
Interface: USB-C
Input: 9V-2A,12V-2A
Mobile phone output: 5W/7.5W/10W/15W
iWatch output: 2.5W
Airpods: 5W
Compatibility: support mobile phones, Airpods, and iWatch that comply with the
Qi standard
Steps for usage
The device is connected to the power supply through the charging cable, and
then it can be powered on. When charging the mobile phone, place the mobile
phone flat in the mobile phone charging area to start charging the mobile
phone. After fully charging, simply take off the phone, during the charging
process, if you need to terminate the charging, take it directly. When
charging the Apple Watch, place the iWatch flat in the charging area to start
charging the watch. After fully charging, directly remove the iWatch; During
the charging process, if you need to terminate the charging, remove the iWatch
directly. When charging the Airpods, place the Airpods flat in the charging
area to start charging ;
After fully charging, simply remove the Airpods; During the charging process,
if you need to terminate the charging, remove it directly.
Special Note:
- When charging the watch, recommended using flat and vertical charging at 90 degrees. Do not select 30 degrees, as charging may not be possible at this angle.
- Recommended to use the supplied charging cable for the power supply, and not to use the original iPhone cable.
Packaging accessories
3 in 1 wireless charging 1
USB-C charging cable 1
Manual 1
Packing box 1
The content of this manual and product specifications are subject to change
without notice
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
the device, a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>